Jmike
-
Posts
11 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Articles
RPO
Store
Blogs
Everything posted by Jmike
-
I believe it has a slight rake but I can barely tell.
-
Apparently they are different for the 19 (ford convert so not sure about previous models) and have a very small gap between the tire and ball joint. If you were going with aftermarket, I'm sure an offset would cure that but I wanted to stay stock for my wheels. I'd say nothing wider than right at 11.5" would work. The guy at the shop said they would have probably cleared with a 2" level but I wanted a little higher ride so went with 3" rough country.
-
Finally got it back. turned out pretty good in my opinion. 35x11.50r20 ridge grapplers have just enough space between ball joint and tire. No rubbing no trimming. They do run a little small so same size trail grapplers might require a little trimming.
-
No, the inside of the tire was right against the ball joint when mounted to the truck.
-
Yes stock 20s. The guy at the shop said it cleared turning so hopefully the 1/2" will let it clear the control arm.
-
Well I'm going on day 2 without my truck back. The 35x12.50s were too wide and kept hitting the control arm. Tire shop is ordering the 35x11.50s and they will be in tomorrow.
-
It is steel. Kit comes with new a-arms and shocks & blocks for the rear. I was going to go with readylift's 4" lift but decided to go with the cheaper 3".
-
Just dropped off my truck to have rough country's 3 inch suspension lift installed with 35x12.50r20 Ridge Grapplers on stock wheels. I'll post pictures after I pick it up.
