TedS

The truck sets level, I replaced the Fabtech 1.5" Block with a 2.5" Block to make it level, I was going to go with a 3" block but the U-bolts from Fabtech were only long enough to go to the 2.5" block for now . I'm going to have the rear leafs re-arched or add-a-leaf. If I add-a-leaf I'll go back the the 1.5" block and gain it that way, just another $300 to $400 I don't want to spend yet.

Wheels are XD132 RG2, 18x9 Running boards are Steelcraft STX300 They tuck up nice and direct bolt to factory nuts. One clip used went into a factory hole, great setup.

Got my 2019 LT and had to get more clearance. 3.5" Fabtech with new Dirt Logic Coil Overs, added 1" lift with 1/2" spacers between Coil Over and lower control arm. I measure 4" lift. Dick Cepek 33x11.5x18. Wheels are XD132 RG2, 18x9 Running boards are Steelcraft STX300. They tuck up nice and direct bolt to factory nuts. One clip used went into a factory hole, great setup.

I just got back from the dealer for the first oil change at 5,500 miles, oil change and break life at 17% front and 20% rear. They said the pads are good and reset it. I checked the Driver Information Center and they just turned off the Break Pad Life System. It's not fixed so I'm calling GM in the morning to get the bulletin number your referring to. If they give me one I'll drop back in and provide it. The calipers have a set of wires coming off of them and a plastic cover. I imagine there are sensors in there and something isn't working correctly. Another issue is the LCD temperature control doesn't always follow the manual knob controls. It always works but if i go from radio to LCD climate control it shows a black screen. It's blowing cold air but nothing displayed. They said GM knows and working on a patch. I'll find out if that true too tomorrow.