Jump to content

BigballR

Member
 View Profile  See their activity

  • Posts

    20

  • Joined

  • Last visited

 Content Type 

Everything posted by BigballR

  1. BigballR
    Appreciate it sir!
  2. BigballR
    Which bushings work on a 2008 4.8 Chevrolet Silverado transmission shift cable?
  3. BigballR
    Is there an easier way to remove the fuel tank pressure sensor on 2008 4.8 Chevrolet Silverado than lifting the bed and dropping the fuel tank?
  4. BigballR
    My ac cycles on and off but the air is cool, do I need a ac pressure switch because I can't get the ac clutch to stay on long enough to recharge.
  5. BigballR
    I am removing the front brake rotors from my 2008 4.8 Chevrolet Silverado and the torx screw broke inside of the rotors and I can't remove the rotors, can I drill it out?
  6. BigballR
    Appreciate it!
  7. BigballR
    I lost the bolt for coil pack bracket putting on the last firewall bolt, do I really need it?
  8. BigballR
    Is there a easy way to remove the last bolt on coil bracket 2008 4.8 Chevrolet Silverado LT?
  9. BigballR
    When I crank my truck in the morning blue smoke exits the tailpipe and the truck seems like it is flooding but the smoke clears up and the truck is running smooth . What seems to be the problem?
  10. BigballR
    I'm trying to get this right so here are the questions, warm engine up for 5 minutes, remove fuel pump fuse and fuel injector fuse ,crank truck until it runs out of fuel and turns off. Remove all spark plugs and since po302 code is the only misfire start with it and hope it's over 100psi .
  11. BigballR
    Do I put my OB2 scanner on since DTC's were cleared or since last drive cycle? I disconnected my battery to install a passenger door open actuator because interior lights stayed on.
  12. BigballR
    Check engine light came on and code scanner reads cylinder 2 misfire, so I changed coil pack, spark plug and wire but it runs awhile and engine light came back on.
  13. BigballR
    Appreciate it sir!
  14. BigballR
    I have a misfire code on #2 cylinder, can I switch coil pack on #4 & #2 to see if misfire switches before I buy a coil ?
  15. BigballR
    It grayish and the engine is pointing upward.
  16. BigballR
    I just had new lifters replaced and when I park my truck headed in slanted driveway it will smoke when I crank it up but stops after it starts. It doesn't smoke when on level ground, what is causing this?
  17. BigballR
    Thanks for the video sir!
  18. BigballR
    Where can I place the jack to raise the engine on a 2008 Chevrolet Silverado LT 4.8 ? Do I have to remove the starter to get the passenger side off ?
  19. BigballR
    What is the brake line sizes that go to the master cylinder ports and the fitting size on a 2008 Chevrolet Silverado LT 5.3 liter ? I have a leak coming from the fitting by the new master cylinder.
  20. BigballR
    How do I slide the red tabs to remove ecm?
×
×
  • Create New...