Jump to content

Lowrado20

Member
 View Profile  See their activity

  • Posts

    14

  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Lowrado20's Achievements

Enthusiast

Enthusiast (2/11)

2

Reputation

  1. Lowrado20
    Will pressing the switch say to the left always unfold mirror and pressing to the right unfold or does it depend on the position they are at when pressing switch?? Only asking as I’m looking for a switch and one says in/out.
  2. Lowrado20
    Switch as in the lock switch?? Or do you have a separate switch installed?
  3. Lowrado20
    So with the Amazon module hooked up the way they say to. Does anyone have issues with the mirrors??? More so with a remote start. If I remote start then I have to shut off and restart for the mirror to unfold if not the mirror attempts to unfold but won’t. Maybe I got a bad module??
  4. Lowrado20
    My puddle lights are on the dome light circuit.
  5. Lowrado20
    Ahhh I don’t have a switch yet. But it says when ignition turns on it should unfold. Going to install a relay that gets a signal when shifter out of park and applies ignition to power fold module so they work with the fob and buttons till out of park
  6. Lowrado20
    Ahhh I don’t have a switch yet. But it says when ignition turns on it should unfold
  7. Lowrado20
    Got everything working with puddle lights. The module will not unfold mirrors if I remote start the truck. I have to turn it off and infold then start it. I have tried swapping the dip switch inside but then it folds the mirrors when I turn truck on after a remote start lol
  8. Lowrado20
    To everything installed and for some reason driver side works opposite no matter how I hook it up lol going to try a different way before buying a second module. I had to swap terminal 13 with 5 to get puddle lights to work
  9. Lowrado20
    Only ones that know are boostauto. I found a harness out of a 3.0 LM2 at work and used the terminals to make it work. I also had a harness from the body of a vehicle that had the correct male terminals for door pass through. All wired up like factory just have to finish moding the mirror caps because I’m not going to use the front flood lights. Then wire the module for power fold. For as 2020 the back dome lamp is x1 terminal 23
  10. Lowrado20
    So. OP said he got the puddle lights to work as he had the wires already. I do as well. Also have them at the BCM. Did he have to get it programmed or did they just work?? I have power fold,puddle,front flood light and camera on my mirrors going on. How do all these lights turn on?? Obviously the camera won’t work but I would like the puddle lights to work.
  11. Lowrado20
    So boost auto knows what terminal is used but won’t give the information up. I get it but it’s frustrating. I have a few different terminals I’m going to look into
  12. Lowrado20
    lol that would have been nice to know. I emailed notation but I’m sure they won’t tell me the correct terminal either.
  13. Lowrado20
    i bought the terminals listed and they are too big for the mirror and door connectors???? They use a common ground with the mirror and then are feed power from the BCM..
  14. Lowrado20
    Sent you a message
×
×
  • Create New...