Jump to content

dieseldick

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About dieseldick

  • Rank
    New Member
  • Birthday 12/12/1960

Profile Information

  • Name
    Rick
  • Location
    Cape Cod Mass.
  • Gender
    Male
  • Interests
    Fishing, Autos, electronics, Ham Radio, eating
  • Drives
    2014 chevy Silverado 1500 4x4 DC LTZ Z71 6.2L
  1. I have a 2021 1500 sierra at4. Put a set of 3 led running lights on and tapped off the trailer running light wire. Well these new trucks are too smart. The truck can sense these lights and assumes a trailer is hooked up. From there, it thinks the other trailer lights are not working and warns you constantly. It also makes the side cameras come on when using the turn signals. I'm looking to see if hooking into the tail light parking lights might eliminate this issue. After I posted, I realize my profile is a bit outdated. I had since had a 2018 high country 6.2 and now have the sier
  2. Have a 2014 Silverado 1500 DC 4x4 LTZ Z71 6.2L with factory 22" wheels/tires. I live in the Northeast and winter can be hard on wheels. I also have low profiles on the 22' wheels. I want to find a wheel/Tire setup that is optimized for winter travel, while I store the factory 22's until spring arrives. These 22's where a $2995 option and I sure do not want to ruin these during the upcoming harsh winter season. My concern is, if I were to find a set of 18" or 20", what problems should I be aware of? I suspect my speedo will be off, not sure about tire pressure monitor or ABS effects usi
  3. I have a 2014 1500 DC 4x4 LTZ Z71 6.2L with Projectors on low beam I replaced the low beams with HID and the fogs with LED. I now want to replace the 9005 highs with HIR bulbs. I hate these dust caps you need to remove. Takes me 2 seconds to replace the bulb and 15 minutes to get those dust caps back on. Well this is true of the upper low beams anyway. My question is... Am I going to be able to remove the high beam dust caps or do I need to pull the whole assembly? Looking at the bottom high beams, these dust caps look like they may hit the chassis first before I can twist them eno
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.