CKrado

I recently traded in my 2017 Silverado 1500 and have some OEM and aftermarket parts laying around the garage that I no longer need. Some items will fit other vehicles like Sierra's, Tahoe's, Yukon's, 2500's and 3500's. I am not responsible for verifying fitment on your vehicle. I am located in the Kansas City metro. Local pickup is preferred but I am open to shipping. Pictures in comments below. D5S LED headlight bulbs from HID Concept - $100 About 1 year old Huge improvement over stock HID Plug and Play https://www.hidconcept.com/products/d5s-dama-kanji-ultimate-vision-gen3-kuv-6000k-led-bulbs-pack-of-2 2016+ Silverado Baja Designs Fog Light Brackets - $180 Sku 447536 Brackets ONLY, reused the LEDs on a different application Works with all Squadron LED lights https://www.bajadesigns.com/products/chevy-squadron-sport-fog-pocket-light-kit-chevy-2016-18-silverado-1500/?vid=140546&sku=447536 2017 Instrument Cluster - $100 out of a Silverado 1500 LT, was removed from truck for a HC swap in 2018 and stored wrapped in a box. will need to be reprogrammed by a company like WAMS Will fit other full size 2017 GM vehicles OEM floor mats - $40 Will fit Crew and double cab 1500-3500 Will NOT Ship Kicker 400W subwoofer kit - Will NOT ship Sku 19303117 Fits 1500-3500 Silverado and Sierra - Crew cab ONLY Has 200w sub amp and 200w speaker amp with DSP Sounds really good and was a huge upgrade for the factory sound system All harnesses included Local pickup ONLY https://accessories.chevrolet.com/product/200-watt-subwoofer-and-400-watt-amp-kit-by-kicker®-associated-accessories-19303117?bac=231232&body=Crew Cab Pickup&bodyId=22&bodyNumDoors=5&bodyNumDoorsId=5&drive=4WD&driveId=8&engine=5.3L V8 GAS&engineId=2059&make=Chevrolet&makeId=47&model=Silverado 1500&modelId=491&trim=LT&trimId=430&wheel=Short Box&wheelId=651&year=2024

Yes you can install 5100's on your current Rough Country lift. If you place the circlip in the lowest groove of the 5100 shocks then that is setting the height to factory. Then just reinstall with your rough country kit and you'll be good to go. The rear 5100 shocks are non ajustable.

Baja Designs fog light upgrade kit for 2016-18 + 2019 Legacy Chevy Silverado's. I went with the white sport squadron lights (447536). Purchased on ebay from the link below, made an offer for $420 that was accepted. https://www.ebay.com/itm/233376576607 Recently installed the white sport lights on my 2017 Silverado 1500. Installation was a bit challenging (not because of Baja designs but because of the hardware GM used during manufacturing). Total install took about an hour from start to finish with the most difficult step being the removal of the (4) screws holding in each OEM fog light - you will want a joint socket. The brackets exceeded my expectation, made of very durable thick steel that fit perfect in the OEM fog light location. Installing the squadron lights was made extremely easy with Baja Designs plug-and-play adapter. There are no fuses, replays, or wires that need to be ran anywhere!! The lights in the sport kit came with the wide cornering lens. I tested the lights out the same night after install and was very impressed how much light lit up the ditch and tree lines to both sides of the truck. It was also raining outside, the OEM headlights and fog lights were never good at illuminating wet roads but these BD lights made the wet road very visible. Overall, very happy and pleased with this kit and would recommend to anyone looking for an easy light upgrade without needing to run wires to a battery or switch.

No and there never will be from those. There is only one set of fins that go into the shutter motor and those are the ones that control tell the computer when they are opened and closed based on another little tab they have on them. All the other fins just clip into place and have a plastic rail the delivers the movement from the fins that go into the motor. So when I popped out the bottom two rows the computer will never know. The fins that go to the shutter motor are the third row from the bottom.

For the most part I followed this thread, I did a couple things differently like instead of trimming some shutters, I just removed the bottom 2 fins on both sides since they just pop out. And instead of cutting the entire rough country bracket close to the bolt head like that member did, I chose to trim a portion of the back side of the grille to fit around the bracket as shown in my pictures below.

Got rough country light bar kit installed even with my grille shutters. Just finished my switch writing this morning so will test the light out tonight. Happy with the end results! Sent from my SM-G955U using Tapatalk

Also did this install on my 17 Silverado LT. Only removed the lower 2 rows of shutter fins and then all my other trimming was don on the grille itself. Very happy with the finished product but wouldn't have even thought of the install option without the forum topic. Sent from my SM-G955U using Tapatalk

I’ve had that issue before too, it really does suck. Was not the case with this cover. Everything lined up, the most difficult part is modifying the brake line bracket. All you have to bend it a little but you have to do that with any aftermarket cover. Sent from my iPad using Tapatalk

It’s the G2 brute cover with drain plug and dipstick. P/n 40-2091mb Quality and fitment are great, very easy blot on install. It’s comes with everything you need for the install minus fluid (new bolts and gasket). Sent from my iPad using Tapatalk

Ordered rear bilstein shocks on Tuesday expecting delivery today but to my surprise they came in yesterday. After work I installed them in about 30 minutes and they’re by far much better than the black OEM shocks Sent from my iPad using Tapatalk