Jump to content

Shamus

Member
 View Profile  See their activity

  • Posts

    5

  • Joined

  • Last visited

 Content Type 

Everything posted by Shamus

  1. Shamus
    Yes
  2. Shamus
    I am trying to determine if it needs a new PCM, the crank sensor and cam sensor have just been replaced and the crank sensor is performing properly via volt test.
  3. Shamus
    The two grounds on the rear of the engine when disconnected one will light the test light when cranking that’s the pass side one the drivers side one does not light the light .the ribbon ground is good and clean. The other two have new clean terminals
  4. Shamus
    Yes and ground and when I crank the starter another wire dimly lights the test light. But the 4 th pin has nothing not - or +
  5. Shamus
    Grounds cleaned and good. New crank position and cam position sensor. Truck was running then quit. No spark, get fuel, with key on hand crank engine relays click and the fuel pump cycles
×
×
  • Create New...