MuskokaMike

I can get any 2 working in any combination but can't seem to get all 3 (signals, running lights, brake lights) working at once. Here's what i have so far. Input harness to the connection block is 7 wires. I'm wiring directly to this harness, bypassing the connection block. Black = ground Brown = running lights Blue = left or right turn (can't remember which blue is which) Blue = left or right turn Blue = Stop ( the blue opposite the blank spot) Green = reverse Brown/white stripe = running lights (I'm assuming the extra brown has something to do with the running lights staying on until you open and close the door) Tail light harness from 90's era box has a 4 pin connecter and a separate ground wire. Brown = running lights Yellow = left turn Dark green = right turn light green = reverse Black(separate) = ground Where does the brake light (blue) wire hook to? If I don't hook up the blue (brake wire) i have running lights, signal lights and the brake light on the cab works as it should If I hook the brake wire(blue) to the brown, I have brake lights and signal lights but no running lights If I splice the brake (blue) in with the brown to brown, I have signals, running lights but the brakes don't make the tail light brighter when applied and the brake light on the cab stays on with running lights. If I pigtail the brake (blue) to both signal lights ( yellow and green), I have running lights and brake lights but when I activate left or right turn signal, both sides flash like 4ways,,lol are they just not compatible? Is there no way to make everything work at once?