jim larson

It’s the average fuel economy for the last 50 miles, shows up black except for Milage since new. Just went bonkers. How can I add this page back? Or is this a big problem? Thanks. Any way to add a photo to this question?j

1. CEL is now off because I reset the system by disconnecting the battery for 15 minuets. But problem could still exist. I don’t want a $400 plus bill for the dealer to replace the sensor which will get me about 1/2 mile per/g with a little more efficient burn. 2. would be nice to over-ride the issue;but how do you decide the issue? Thus the NAPA code reader. Will it work with the CEL off?? 3.I have read the manual at least 3 times. I have also done internet search’s. Yes cas cap is on as it doesn’t have one, maybe something to do with flapper. Maybe wire to hood latch, and maybe other issue. Going to to NAPA. Hoping they can identify the problem.

Hi, my remote start would not work, check engine light on. I disconnected battery cable, let it sit a while, re-connected battery cable. Started car, no engine light. Put new battery in remote. Remote start does not work. Check engine light does not come on. Any idea why remote start will not work? Would like some ideas before I go to a dealer. Possibly some kind of emissions sensor or a fuse? Can NAPA check the code if there is not a check engine light on? Thanks

Hi thanks to all for help on 3rd brake light wiring to appropriate connector. Now how do I wire the Topper dome light to the factory Installed LED pickup bed lighting. This is a 2017 Silverado 1500 Crew Cab, 4W drive, LTZ Z71. Thanks in advance.

Got tired of the fold-a-cover and when back to a topper cap on my 2017 silverado crew caab. Bought used, I have lights in my box, so just need to hook up the brake light in the topper. So I don't want to use a 4 pronged harness. Unless there is a close spot where I can get power for the topper light switch. Is there any such animal as I don't want to take t he time to run a wire to the battery for that. So what the best way to hook up the brake light? Just cut the plug off from the part of the harness in the topper? Then how do I connect the two wire to something back where the wires are for the rear tail lights?

Looking for a photo of the rear fit of a 2013 topper on a 2017 short crew cab

​ Rocks hit the front of the boards and bounce up and chip the bottom of the doors. You have to do something like this guy did.

​factory boards are c....., pit and rust. stainless is the only way to go. and you have to protect the bottom of the door from rock chips like above.

I have a 2014 Lt silverado 1500 with the standard mirrors (no tow Mirrors), will this work on my truck? So all I have to do is buy your harness or do I also have to buy a new set of mirrors?

Is it possible to add/replace an interior or an exterior self dimming mirror to a 2014-2017 LT similar to what is standard on the LTZ? Thanks

Ok, I have it; but can't find the switch.

Roll n Lock or Rollbak G2? Any comment or recommendations? What about durability, water leakage, dust leakage, the fit, etc. Thanks.