Divide Wee
-
Posts
9 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Articles
RPO
Store
Blogs
Everything posted by Divide Wee
-
I have been pulling the neg battery cable every time I have towed the truck. Has anyone found a decent way to install a disconnect on a 2020 or newer 1500 pickup?
-
Satellite Signal Lost
Divide Wee replied to Divide Wee's topic in Troubleshooting, Warranty & Recalls
The dealer replaced the shark antenna without fixing the problem. The dealer ordered a cable running from the antenna to the radio after talking to Chevy. The cable is not available at this time. I feel that this is a software problem due to the fact it will work properly after the restart. I really don't want the dealer tearing the interior trim apart to replace something I don't believe will correct the issue. -
I used the raised black metalflake on my Shadow Grey. More subtle in low light.
-
Every week or so, I get a message on the screen "Satellite Signal Lost" when I start the pickup. Sirius will eventually reconnect after turning the pickup off and waiting a few minutes before restarting it. Is this normal and everyone is putting up with it or do I possibly have a problem that I need to get taken care of by the dealer?
-
I want to install a small winch in the bed of my 2020 Silverado to pull my motorcycle up a ramp into the bed. Normally I would just tap the positive and negative posts of the battery and run cable to the bed. Given the lack of decent access to the positive post, has anyone found a good way to tie into the system? This would be needed to install a winch, snowplow or any other heavy electrical accessories.
-
Rosepaul is right. GM states the neg cable should be pulled.
-
I dug further into the owners manual and found the answer I was looking for. Thanks for the answer.
-
Why would I only disconnect the neg? I do know there is a complicated mess on the positive side but disconnected is disconnected, isn't it? Are there circuits that stay energized even with the neg pulled loose?
-
I have an LT 4X4 I am going to tow behind my motorhome. GM calls for the battery to be disconnected when the truck is flat towed. Has anyone figured out how to install a disconnect given the integrated cover over the battery? There doesn't appear to be anyway to easily re-clock the positive cable to be able to install a cable to the solenoid. I haven't contacted GM about this but hopefully they have a workaround.
