ChrisMatthews

Dave what do you make of that picture? Everything I've seen labels the ports thus way: top left is right front, top middle is left front, top right is rear line, bottom left is rear master, and bottom right front master. If anything, it seems to me to be obvious the front right goes to a bottom port.

Thanks Dave. Clips were pita, but patience and determination won in those. I took pictures, lots of them, trouble is the lines twist over the frame by the firewall. Also the pictures I took help quite a bit, however it only takes 1 out of the bunch to mess you up. I planned on paying close attention near the ebcm, but the lines snapped like dead branches. Looked at several trucks, all a bit different. I did gain perspective on the lines going through the clips though. Haven't yet determined if that helps me or not yet.

Going to drive around to look for another truck with intact lines.

I know from the only color code left my Rear Master cylinder line goes into the Top Middle port. I also know the line running to the rear (drums by the way) goes into the Top Right port. I am also fairly confident the Left front (Driver's side) line goes into the Top Left port. Other than that....HEEELLLLPPP!

I have a 2006 GMC Sierra 4 x 4 Crew cab SLE. My lines are the tc04 727. They DO NOT go into the ports like everything I've seen says. The only diagram I gave found is from dealership or nemigaparts. It does not clearly show proper routing/port locations. I'm at my wits end here.