brian.yi15

Almost done with the DOD/AFM delete and finally putting the head back on. I cleaned out all the holes for the head bolts but I’m struggling to fully go through the torque spec. 59 ft lbs, 90, 60 (40 on the allen). I can do the first pass but then on the 90 I struggle to do most of the bolts and I’m putting my whole back into it. Should I pull the bolts back out, clean out the holes again, and would I be able to reuse those bolts since I didn’t do the full torque sequence or just send it and tighten the TTY bolts as much as possible within the torque spec? 2018 Sierra 5.3 L83