Cdoan3

I've read the install instructions on the belltech website and see what everyone is talking about. Had a look underneath and the block is gone. But my truck sits half inch lower in the back so I might put a half inch block in to get it level or even a very small rake. Not a fan of the squat look and I can't un see it lol.

Part #6401 http://www.belltech.com/products/belltech/rear-lowering-components/lowering-shackles/shackle-kit-12892.html

Belltech has a 2-3" adjustable shackle available. My dealership orders the shackles in and when I got it back that's what was in there. When I looked underneath it looks like the guy that installed it lifted the box cause the seam isn't folded. I looked up the part number to find this out it was the 2-3" adjustable shackle. I'm thinking of putting the adjustable strut belltech has so I can get a 2-4 drop without flipping the axel. Oh and I have no vibration or anything with it at the 3" hole.

I have the 3" shackle in my truck with the block still in and there isn't much clearance between the bump stop. With the block out i would have to cut the bump stop or get aftermarket one.

That's true haha. I've got a few different colours of vehicle wrap so I can change my emblem any time, red being one of them lol

Put the belltech 2-3" shackle in the back a couple days ago and left the block in. Truck sits with a 1/2" squat with it installed at the 3" hole. The front probably pivitided upward slightly to make it lower in the back now. Thinking of going to the 2" hole and hope it'll make it a 1/2" rake cause I'd much rather that. this thread has been super helpful just reading it. Here is what she looks like with a slight squat Wanted to call it darth vador but someone beat me to it on here lol