Crankycolnago

Just picked up a used leer camper shell and will like to know if anyone has the wiring instructions and set up for the wireless lock of the shell ?

if you were in California I would take it

I have a dash icon light, the switch itself does not illuminate , I tested the yellow wire that goes to the engine bay and it has no power . So then I need to add a wire to the relay prong labeled 87a ? currently have as follows 30 - 12 v battery power w fuse 85 - yellow trigger wire 86 - ground for relay and light 87 - power to light i ran a power wire from battery to light to test its ground and it works . so it seems that the problem is the switch trigger wire. thanks for the help

Hey Phil Thanks for the quick reply, the truck is a 2016 .

Yea , not bashing him just saying that im using his harness, sent him a message earlier today so well see when he replies, maube he can walk me thru it.

I am using Gamboa harness , followed video and harness tabs instructions double checked all my wiring in and outside . But the light switch does not seem to be triggering the relay, I watched the video and he says put the trigger wire in to #86 on relay but the diagram he has on the vid and the videos showed him putting the trigger wire in to #85 I’ve tried both and there is no juice going to the lights , I have power from main wire to relay , my ground is good and the lights work if I put power to them. The oem switch was bought new and it activated the Icon on the dash . anyone had this issue any suggestions ??

Yes i did have the spray on liner, if fits perfect. I just drove the truck today and holly crap!!!! the dampening of the bed makes it feel like a total different vehicle. now the bed doesnt sounds like a large tin can when i hit bumps. Highly recomended.

I’m thinking of getting one too I really don’t want to start messing w a tune yet

Just got my bed rug in and installed it took about 30 minutes to do so and it just looks bad ass . Next is a roll in hard cover to replace the soft one I have .

Drove it this morning and I hear a fluttering sound . NOT a fan of that sound. was hoping for a different type of noise. :-(

Intake !! Came in last night slapped it on today

I used this one Megulla Truck Bed Light Strips, LED Truck Bed Lighting Kit with On/Off Switch and Fuse -Super Bright LED, IP67 Waterproof -for Trucks, Trailers, Pickups, RVs, Vans and Cargos (Cool White, 6000K) https://www.amazon.com/dp/B0711FYXSM/ref=cm_sw_r_cp_api_i_I2srCbPSWVYD4. I tapped in to the trailer light connector quite easy to do actually .

Finally finished the bed lights and plasti dipped the chrome tailgate letters

I like the roll bar looks Bad ass do you have a side pic

Anyone has the part number for the harness for a 2016 ? I looked up this part number and it says it won't work on a 2016 part #22878806

I am experiencing the same problem , blown out fuse for rear slider and charging pad does not work . I Think ill unplug the charging pad and see if solves the problem .

New to me 2016 Silverado midnight edition 2 inch lift (I think ) air compressor. Haven’t owned a truck since I was 16 so it’s a big adjustment . Looking to do some subtle mods nothing crazy