black-n-gold

Just finished installation. Took me a little longer due to being very meticulous about routing the wiring harness. I used a different method of connecting the wires though. I routed my wires all the way to the engine compartment and went in through the large grommet under the brake booster. Then I connected the blue and green wire to the grey/green and brown/yellow coming from the x6 bcm connector(pink) just to the right of e-brake pedal. Pins 2 and 4 as per http://www.gmupfitter.com/files/media/photo/474/2014%20BBM%20Electrical%20section_10_18_2013_WIP.pdf page 155 and 156. What I did was skim a very small amount of wire insulation off and soldered the wires together. To me it seemed a lot easier then taking apart the door sill. edit: Oh yeah, 1 click of the remote unlocks the drivers door only, and 2 clicks unlocks the rest including the tailgate

Electrical and chassis manuals among other manuals http://www.gmupfitter.com/pdflists/view/34

During my search for the k9 bcm x4 location and pinout I found this lovely piece of information. Electrical Manual http://www.gmupfitter.com/files/media/photo/474/2014%20BBM%20Electrical%20section_10_18_2013_WIP.pdf

Newdude thanks so much. Awesome

Shotmark. I just searched gm #22997089 On ebay. Paid $173

Hi. I need some help installing the factory remote start on my 2014 silverado 1500. I know the dealer needs to program the fobs. The part I need help with is figuring out where the wire from the hood latch goes. I bought the gm 22997089 kit that came with the new hood latch with the pigtails coming out of it and the wiring harness to plug into the hood latch pigtail. The kit also came with 2 fobs with auth code. The wiring harness has 2 wires, black and green. I am assuming the black is a ground and has a lug attached. The green wire I am assuming is for the hood ajar signal. Does anyone know where to attach the green wire???