02cetransam

I spent quite some time on the fence as to whether or not it was worth the time and money to complete this conversion. Looking bad, it was 100% worth it as the console is so much more functional than the bench seat and besides, it looks classy. That being said, for the members who posted earlier on that said it can be completed in 2 hours, I'm not sure how that's possible. I think realistically it will take 4 to 6 hours to complete. It's not a difficult job but it just takes time especially if you want to do a clean installation, having everything working and solder all the connections. The instructions posted here at well done and I am grateful for everyone who has contributed. My only suggestion is not taking off the radio bezel stuff (not needed as you can install bracket using the cubbyhole after you remove ashtray) and using an end off your extra wiring harness to power up the usb ports as it will provide a factory connection (there are 4 wires but you only need to use 2 of them; red and black).

Here is a list of prices and corresponding item number I used for my conversion. I purchased everything through gmpartsdirect as I found them to be the cheapest over all. -------------------------------------------------------- Part: 22776807* Category: All Description: BRACKET Min.Qty: 1 Unit Price: $13.09 Quantity: 1 Ext.Price: $13.09 Core Charge: $0.00 -------------------------------------------------------- Part: 22817347* Category: All Description: PANEL Min.Qty: 1 Unit Price: $20.62 Quantity: 1 Ext.Price: $20.62 Core Charge: $0.00 -------------------------------------------------------- Part: 22995086* Category: All Description: PLATE Min.Qty: 1 Unit Price: $145.52 Quantity: 1 Ext.Price: $145.52 Core Charge: $0.00 -------------------------------------------------------- Part: 23466980* Category: All Description: CONSOLE Min.Qty: 1 Unit Price: $318.91 Quantity: 1 Ext.Price: $318.91 Core Charge: $0.00 -------------------------------------------------------- Part: 23467516* Category: All Description: PANEL Min.Qty: 1 Unit Price: $21.27 Quantity: 1 Ext.Price: $21.27 Core Charge: $0.00 ================================================================== SUB TOTAL: $519.41 SHIPPING: $103.87 TAX: $0.00 TOTAL WITH TAXES: $ 623.28 * indicates special order item, which is a special order non-returnable part.

I used these part numbers. The only thing extra needed to buy are the two bolts and an micro usb cable to make a male to male connection are you are set go.

After

. Thanks for all the help. I was able to get everything working (front sub only for charging) as it should. This site is great. Before

Thanks for all the info! This site is great. I'm almost complete in term of the jumper seat to console conversion, but where is the hmi free slot? I used the extra connector from the console harness and plugged it into front the 3 usb but only put power to the red wire and black to the ground. I left the other two wire tied up. It would be awesome to have the front usb ports to function just for charging. Thanks again.

This one was right after the leveling kit install.

After the 2 inch leveling kit and wheel alignment

Before the levelling kit

Hello everyone. I am new to the site although I frequent the site often. So much useful information. I have a 2014 Silverado Z71 LT. I just picked up a brand new set of 20 inch LTZ rims today and have a 2 inch RC lift on order. Here is the progress thus far.