Ok, so I spent the last hour reading through this thread and this specific question wasn't asked. So the BCM handles the task of turning the fogs off with the brights and there hasn't been anyone who has successfully attempted to bypass this either...but with that said, is it possible, with the combination of jumpers, switches or relays to use the unresponsive fog light switch to toggle on/off a light bar? it would seem that You would need to intercept the fog light switch before the BCM and have that go to a relay that goes to another relay that is tapped into the high beams signal. This would allow power to the relay controlled by the fog light switch only if the highs at on. Or would I be able to tie into the high beams power source going to the fog light controlled relay allowing the use of only one relay rather than two. Any ideas?
