RonnyR

I have had several people asking for the files for the mod. Here is a zip file containing the files that I used. I modified the tilt mount to accept the 3M tape. There are also 2 camera plug files. The file called Camera Plug1 is the original but for some reason (probably different 3D printer setup) the plug was too big to fit my truck. I drew up another one that is slightly smaller called Camera Plug2. I also included some zip tie mounts that will accept the 3M tape. I had some 1/4 inch split looming that I ran my cable thru for added protection. Hope this helps. Let me know if y'all have any more questions. Camera Housing files.zip

I think it is VHB. it is 13 mm wide. It holds great. I also want to mention that I got my camera jacks relocated in the bed of the truck.

I should have paid closer attention to matt99199's cable ends. They need to extend like his is shown. I had to use a heat gun and warm up the PLA plastic sleeve and push the connector past the flush point to get it to make connection. While it was hot and pliable, I pushed it into the camera port to get a molded and snug fit. I also modified the swivel mount to recess the 3M tape 1mm to allow a flush mounting (no holes drilled in the camper). I attached the stl files for the swivel mount and some zip tie mounts if anyone wants them. They accept the 3M 13mm tape. 4mm_cable_stick_down (1).stl Tilt Mount.stl

Got mine ready to install this weekend on my Jayco 30ft Fifth Wheel. The 3d printed parts look great. I made a mod on the swivel mount to recess the 3M mounting tape 1 mm. I will be relocating my camera connections to inside of the bed also. Thanks all who contributed to this build. Will post pics when I figure out how.