Search the Community
Showing results for tags 'volume'.
Found 3 results
-
(2019 Silverado 1500 LTZ) It is intermittent but as soon as I plug my phone into the truck via USB-C cable and connect to CarPlay, eventually during my drive when I try to adjust my volume it is super delayed to register the volume change. After a couple minutes the entire dash goes black and restarts. Almost like the infotainment system freezes. No idea what could be causing this and there isn’t anything out there regarding my issue. Any ideas? -
V-6 2019 Silverado calls for 6qts of oil. During an oil change, I drained all the oil out and changed filter. Truck is sitting on level ground, and all oil was drained until the last drop came out. I pre-filled the new filter to the top with oil, which left me with 5 3/4 ish quarts of oil. I put the rest in the truck. I started my truck and let it run for a good five minutes or so. Shut it off, and let it sit for about an hour. I came back out and checked the dipstick my dipstick only shows half way. I even really stuck the dipstick down in the oil and “spun“ it a few times to make sure it picked up all over. Same thing. then I started thinking that Oil was not “sticking“ to parts of this dipstick. As you can see from the picture above; there’s oil on the very top of it, but nothing in the middle section. So I tested my theory and went and stuck the dipstick in an old bottle used oil. It stuck all over it with no problems. i’m guessing it would probably take another half a quart or so to at least to get it up to the full mark. What the hell is the deal ? when Chevrolet specifies 6 quarts of oil for this engine, they clearly state that this is “with filter“.
-
How can I stop the truck from chiming upon start up? There are other articles about listening to the radio with the doors open, taking out the keys, attaching seatbelt overrides, but none of them address how to prevent the truck from chiming six times when starting it. Within the IntelliLink settings there is a way to lower the volume of the startup chime, but not completely stop it. Is this a hard wire override, software setting, OBD2 delete? Thank you.
