jusd33

Hello, Driving to work this morning, and it appears my control arm bolt snapped.......Would anyone happen to have the part number for the right lower control arm bolt, washers, and nut? right side.. the rear bolt of the lower control arm. Its a 2015 Silverado 1500, 2WD. Thanks in advance! Justin

Hello, Driving to work this morning, and it appears my control arm bolt snapped.......Would anyone happen to have the part number for the right lower control arm bolt, washers, and nut? right side.. the rear bolt of the lower control arm. Its a 2015 Silverado 1500, 2WD. Thanks in advance! Justin

Got the blinkers and the running lights working. What is this 3 diode thing ?

Thanks for the clarification! That’d be awesome if I can just wire it there. So according to the picture you posted my wired would be -Signal on the glass (+) (pin 41) -lights (-) (ground ?) where would I ground this ? Pin 2? -Reversing light (+) (pin 9?) -Clearance light (+) (pin 11?) It looks like the door jam connector runs to this junction... is it possible to just splice it here. (It seems tough to get to that door jam connector )

Thanks for the clarification! That’d be awesome if I can just wire it there. So according to the picture you posted my wired would be -Signal on the glass (+) (pin 41) -lights (-) (ground ?) where would I ground this ? Pin 2? -Reversing light (+) (pin 9?) -Clearance light (+) (pin 11?)

I understand it’s not plug and play. And Pgamboda sells the harnesses. I was wondering if anyone knew where I can splice the wires into .

I have a 2015 Silverado 1500 LT CC. I recently purchased tow mirrors and installed them. The tow mirrors I purchased came with the wiring for the lighting if your truck didn’t come with mirror lighting. Theres four wires I need to splice in somewhere (per mirror) The wiring diagram they gave me was vague and I’m not too sure what all of the lights are: -Signal on the glass (+) -lights (-) -Reversing light (+) -Clearance light (+) I am an avionics guy for airplanes so I’d say I’m ok at wiring. I tried tapping the blinker wire into the BCM but blinker wouldn’t come on. I also read the you really shouldn’t splice into the BCM. Does Anyone have advice for running these wires and where I can tap into ? P.s. I know someone on here sells a harness, but I don’t want to spend extra money if I don’t have to. I already ran the wires in the cab.