Jump to content

vandenbroekjj

Member
  • Content count

    8
  • Joined

  • Last visited

Community Reputation

0 Neutral

About vandenbroekjj

  • Rank
    Enthusiast
  1. Does this apply to Vin T motor Sent from my iPhone using Tapatalk
  2. Noise coming from my dash

    Did you ever figure out what this was? Sent from my iPhone using Tapatalk
  3. Maybe beginning signs of fuel pump going out? Throw a pressure gauge on it to see if it's weak? While running. Sent from my iPhone using Tapatalk
  4. 99 silverado 336k one owner 2 tranny rebuilds 3 water pumps last one was 3 days ago. Oil changed every 3k miles starting to have some oil pressure issues but still a strong motor when she is warm Sent from my iPhone using Tapatalk
  5. Yeah mine runs at 40 down the highway. And higher if I get on it. I'm really on the fence aout the high volume oil pump or just driving the truck until it gets worse. At this point I only have a knock and 0 psi for about 20 seconds if I stay in there and warm it up with about 1500 rpms Sent from my iPhone using Tapatalk
  6. Been using Fram the life of the truck every 3000miles 10w30 winter and 10w40 summer. It's just weird because after the truck is warm it idles at 20 and 40ish when driving. Part of me wants to try to fix it and the other part of me just wants to leave it until it actually stops working Sent from my iPhone using Tapatalk
  7. Good to know I just use it to tow my boat and run to the hardware store just was unsure if it would be a good idea to use it on a high mileage engine over the stock one Sent from my iPhone using Tapatalk
  8. First of thank you to everyone for all the info on here. Alright lm7 with 336k on it one owner. About start up zero oil pressure and associated tick of low oil pressure. Give the truck a little gas and the oil pressure jumps to around 15 psi I have to hold it there until the truck gets warm. After the truck is warm it will idle on its own with around 20 psi. When driving the truck sits around 35 to 40 psi. Changed sending unit and cleaned underneath it. Used manual gauge to verify correct pressure. Leaning towards the o ring being worn on pick up tube. But I'm going to change the pump as well melling m295hv is what I was looking at is the high volume worth it? Just wanted to see if you guys think I'm going in the right direction with my troubleshooting thank you in advance for your help. Sent from my iPhone using Tapatalk
×

Important Information

By using this site, you agree to our Terms of Use.