linkz1

after I brought it home

Just traded my 2015 1500 in on a 2018 2500hd

I have my light bar on a switch with relay, how Can I hook it to switch off high beams when the switch is on but not when the light bar switch is off. I know where the pin on the brown plug is, but isn't it the ground side of the circuit?

Got my tune files in from BBP and loaded them today. Truck definitely feels better.

Autocal came in today. Scanned my files and data log, now just waiting on the new tune.

Just ordered BBP Autocal!

I did keep the Factory box. I do plan to drop in a better filter in the future. It might have a little more growl than the stock tube but not a whole lot. mostly when you kick it hard. I'm happy with it, just Haven't drove it a whole lot since I installed it.

Installed the Airaid MIT today!

They are easy mount. When you take out the grille there is a lip on the inside wide enough to mount it. When it's on at night you can't see the bars. Here's a pic of it on.

Youre welcome. It's just an Amazon special lol. https://www.amazon.com/dp/B00NG96KNS/ref=cm_sw_r_cp_tai_ywyAybX219TZ9

Thanks! It's a double row 24 " curved. It works good, it's really bright. Here's a wall shot of just the bar.

Plasti dipped my grille today Before After

Just did this today, it worked great. Thanks

If I do the FXR retrofit, can i do the low/high beam mod and wire in the shutter to open and close? I know it's probably been answered but I've been all over this forum and haven't seen it. My plan is to do the above with the fog mod too. So high beam turns all lights on.

I was gonna try it but I've taken my grille and bumper off so much, I just layed it on some pad swapped them. It wasn't to bad.