Search the Community
Showing results for tags 'not working'.
Found 6 results
-
I am having problems with my air conditioning again. My A/C is blowing warm air and this is the second time I have had this problem since buying my 2015 Sierra less than 6 months ago. A few months ago I had the exact same problem and my dealership diagnosed it as a leaking hose and all of the freon was gone. They had to order a new hose and it took a week for it to come in. They installed the new hose and added more freon and it has been fine for the past 3 months until today. This morning I noticed that the air coming out was warmer than normal even though I have the A/C set at 65 degrees. It was fine yesterday. I am going to monitor it and see if it gets worse and if so make an appointment to take it to the dealer again. Just wondering if anyone else has had to replace the hose or had a freon issue with their 2014 or 2015 Sierra / Silverado? -
Just got my first new truck, 18, Silverado 1500. The parking assist was working fine (set to on with tow-bar) and i towed my camper for the first time last week. I turned it off with the button (not the dash computer) and now it wont turn back on. When i start my truck it automatically says Park Assist Disabled. My tow mirrors are in (don't know if there is a sensor in them or not). I have disabled and re enabled and nothing, the switch on the dash will not do anything. Any help would be appreciated. -
I experienced problems with the Shift Buttons for the Manual mode on my Silverado: It behaved like there was a false contact or even an electrical short on the inside of the shift lever The transmission worked fine in Drive, and even in Manual Mode, but the truck would shift down when i pushed the button to shift up and viceversa or not register the shift at all. This was specially problematic when trying to engine brake while towing loaded on a hill or so, you get the idea. After disassembling the Column covers and shifter boot i discovered orange rust coming out of the lever where the cable for the buttons exits, so i concluded it was most likely a false contact or short on the internal electrical parts of the shifter itself, caused by rust and corrosion inside of the shifter. Since i caught the problem relatively quickly i managed to fix it by pouring a lot of AutoZone Rust Eater penetrating oil a few times in a couple of days It worked! now the shifter buttons work like new. Im pretty sure that if the rust had corroded the electronics too much, I may have needed to replace the shift lever entirely, since there is no practical way of disassembling it. WD40 could have worked too, but AutoZone´s "Rust Eater" sounded better and is just what i had in hand and worked. There are many brands of Rust Removing Penetrating Oils, most of them should do the same, but i dont know of all of them are Dielectric and safe to use on electronics. MAF sensor cleaner or Electronic parts cleaner could also work as well. TL;DR i made a video about it, hopefully this will help someone not spend money on a new shift lever: -
The radio stopped working on my Silverado, but found out how to fix it, and I made a video about it, its a really simple fix that works for any 2014+ Silverado:
- 3 replies
-
- 1
-
-
- radio
- not working
- (and 1 more)
-
This weekend someone slammed my passenger door probably to hard in my opinion. Not sure if this is the cause of the problem but the issue did start soon after. The Window and mirror lost power first intermittently, now completely. I checked the fuse and also didn’t see anything obvious as far as wires being loose or broken from the harness. Any suggestions or recommendations for a fix would be greatly appreciated. -
Problem Description: Headlights turns-On and sometimes does not w/ DRL Headlights turns-Off while driving and then comes back On Headlight does not turn-On at initial startup and then turns-On while driving All other lights are functional, Tail Lights Brake light and Reverse are Ok All Turn Signals w/ Hazards are Ok Fog lights (Morimoto XB LED's) are Ok Action: Taken to a reputable shop to troubleshoot; of course the lights were functional the entire time during the visit; issue re-occured later during that day on my way home from work. Any thoughts would be greatly appreciated.