Bob.M

I have a 2014 Silverado and would like to have dual tail pipes but keeping the OEM muffler and flapper valve intact. I am not looking for any performance gains or noise, simply like the look of dual exhaust much like the new 2019 Silverado's or like the Dodge RAM trucks have been doing for years now.

Thanks Chino1777

​I have a 2014 Silverado LTZ which I replaced my rear oem 7444LL tail light bulbs with the Phillips 7443 Intense Red Vision LED Stop/Tail light bulbs which work great with the exception of hyper flashing with the turn signals. I installed the Philips 21W Vision LED CAN-bus Warning Cancellers (one per bulb) and that did not correct the hyper flashing or eliminate the dash panel error message. Do I need a higher resistance value load resistor? The Phillips unit does not provide the resistance value, just the wattage which is 21 watts. I see other load resistors online which are 50 watts 6 ohms. Should I get those?