Whippy62

My Access Cover fits inside perfectly. Now if the Sports Bar mounts to the inside of the bed in any way, it might interfere with the way the cover mounts. Without a picture of the mounting hardware it's hard to know. I have seen some posts from Colorado and Canyon owners that have installed a soft roll up cover with the sports bar. Here's a pic of mine installed with the carbon pro bed and it's inside the bed rails.

Hi, I'm looking at installing a Du-Ha under seat storage box on my AT4 Crew. Do you have a picture of your box installed? Does the storage box interfere with the lip on the floor liners like in the included picture?

When you say "cut a bit" do you mean just some holes to extend the bolts through? or actually trim the liner some? I have the same floor liner and am debating on getting the GM storage or the Du-Ha (leaning towards the Du-Ha). The Du-Ha looks a little bigger and doesn't lock (I don't need it to lock) but does anyone have the Du-Ha installed with the full interlocking floor liners installed? I'm concerned the Du-Ha might not fit because of the raised lip that goes around the floor liner. See attached pic. Also, does the jack mount the same way it is mounted now in the GM Storage box? I can't seem to find any pictures of the GM box with the lid open on the passenger side.

I just installed an Access original roll-up on my AT4. It installs on the inside of the bed rails and rolls up like 6-8" tall . Unless I'm missing something, I don't see why that wouldn't work on yours and they are less than $500.

did you find a good place to ground the wire towards the back of the truck? I'm doing the same thing and I can't figure out where to put the ground wire. Everything is coated in black stuff.