Jump to content

Jon DeLoach

Member
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

2 Neutral

About Jon DeLoach

  • Rank
    Enthusiast

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. here is how i wired mine up using a harness i cut out of a parts truck in a junk yard. i got the same plug from the parts truck then pulled out the wires and pins from it and put the wires and pins in the correct slots in my trucks harness
  2. this saved me so much time and allowed me to figure it out thank you so much
  3. here are some picture and videos of how i installed my upfitter aux switches to my 2017 silverado Texas edition truck which DID NOT com with them nor does it have the relays fuses or switch wires in the harness. keep in mind the switches are GROUND or NEGATIVE switching. which means they DO NOT HAVE 12v ON THEM. DO NOT PUT 12V ON THE WIRES YOUR ABOUT TO INSTALL. i had to get a new connector from a crashed truck in a junk yard which i then pulled 4 of the pins and wires out of to install into my trucks harness plug for the upfitter switch. once i did that it was just a simple act of making a short extension wire from those 4 wires coming from the harness plug to go to the driver kick panel where im going to locate the relays for the devises i want to control. you will see the harness plug and wires where i put them. and you will see the JST plug i used to connect the 4 wires to the extension wire to run to my relays. will also upload videos soon.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.