Jump to content

sully9560

Member
  • Posts

    16
  • Joined

  • Last visited

Profile Information

  • Name
    Brian
  • Location
    CT
  • Drives
    2019 Silverado LT

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

sully9560's Achievements

Enthusiast

Enthusiast (2/11)

4

Reputation

  1. I have these and cannot figure out how to install them. Instructions are bad. I can see how they should go but can't figure it out Sent from my SM-N960U using Tapatalk
  2. I just did my turn signal bulbs and purchased the OXILAM bulbs for the front turn signals that someone else mentioned. I purchased 2 2 packs of LASFIT 7440 Brake Lights. You also have to purchase 8 50W 6 OHM load resistors (2 for each bulb). Haven't had any problems. Links below. Bulbs Load Resistors
  3. Why does your dealer have to let you order a yellow one? You're the customer. If he doesn't want to order one for you find another dealer. Sent from my SM-N960U using Tapatalk
  4. Installed these running boards last night Sent from my SM-N960U using Tapatalk
  5. I was able to use a plastic pry tool to pop the skinny piece in the middle off then the rest slides off Sent from my SM-N960U using Tapatalk
  6. I upgraded my reverse lights to LED and it helped. Video quality is still grainy but lighting is much better. Sent from my SM-N960U using Tapatalk
  7. My Silverado didn't come with homelink so I got that mirror on Ebay for $50. Also has autodimming. Sent from my SM-N960U using Tapatalk
  8. Yesterday I installed this rear view mirror. The plug for the mirror was not compatible with the plug glued in the headliner so I had to do some splicing. I found a constant wire that powers the overhead lights nearby. Hooked the homelink up to that. Sent from my SM-N960U using Tapatalk
  9. I recently purchased a Gentex GENK41A off ebay because it has Homelink. The plug was not compatible with the wiring harness glued in the headliner. A document that came with the mirror said you can splice it. The mirror is a 3 wire setup - Green (ignition), White (Homelink) and Grey. The wiring harness in the headliner is Black, Yellow, Black & Yellow, Purple and Green. I know I can splice the green wires but where would the White wire on the mirror splice to in the harness? The grey wire for the mirror is unused.
×
×
  • Create New...