Smoothbassman

This happened to me this morning. Headed into work hope it works when I get back. Sent from my SM-N986U using Tapatalk

Anyone know how to manually override the parking brake? Had the system fail this weekend to the on position. Had to disconnect the battery to reset the system and get it working again.

If they shine GMC on the ground that would be cool.

I did something similar. Added a better seal at the front and added silicone sealant around all of the edges and it's water and dust tight now.

Yep If it's not on there from the factory, it's impossible to upgrade later. I found that out the hard way myself. Extra USB is easy. Amazon has a lot of options. I added 4 high speed chargers in the rear for my 3 kids.

I think you might need a spacer if those wheels are a stock pre 2019 offset. The brake caliper sticks out father on the new models.

Sounds like something else is going on. Mine works in the back as soon as I press the button up front. Additionally check to make sure your not pulling too many AMPs on the circuit with the device you have plugged in back there. It will turn itself off automatically if that's the case.

This is really nice! Where did you purchase it from. I would like to get this on my truck as well.

Curt Harness

Finished LED

Ok You have a lot here. Let's start at the top. Tailgate Removal Put something soft in the bed of the truck to lay your tailgate on. Remove the two bolts holding the tailgate straps. Once removed you can lift the gate up slightly and pull it off the right side and flip it up into the truck bed. There's a camera harness that has enough slack so you don't have to disconnect it. Light Bar Mount The double sided tape will work fine provided that you use some adhesion promotor on the surface before applying it. No need for screws. It will hold if done properly. Wire Connections Just grab a CURT 55384 Replacement Vehicle-Side Custom USCAR 4-Pin Trailer Wiring Harness on Amazon for 20 bucks. Makes the job plug and play. No splicing needed. Hope this helps.

I need these switches in my life!!! Sent from my SM-N960U1 using Tapatalk

B&W Tow and Stow all day. I have a double ball rotator with a 6 Inch rise Dropper Works great for my 2 trailers with 2 Different ball sizes and trailer heights. Sent from my SM-N960U1 using Tapatalk

OH! OK. This is not the one I say is "Factory" This unit is not integrated into the DIC, but is a good alternative option that fits in the factory location.

Going 12 Wide is the challenge. Found Options for you on Custom Offset's Page. All of these photos looked leveled. None of them are on stock wheels. https://www.customwheeloffset.com/wheel-offset-gallery?wheel_diameter_from=22&wheel_width_from=12.0&tire_height_from=33q&sort=date&year=2019&make=Chevrolet&model=Silverado 1500&drive=4WD