Jump to content

Whatever64

Member
 View Profile  See their activity

  • Posts

    51

  • Joined

  • Last visited

 Content Type 

Everything posted by Whatever64

  1. Whatever64
    I had the tail lights on the drive side go out... no fuse anywhere the stealer finally told me wire goes directly to the BCM that might need to be reset or replaced. Luckily I had the extended warranty and they had the truck four 4 days. The problem they told me they found was a corroded wire under the dash.
  2. Whatever64
    I did google it and found this....... https://ecclesautoservice.ca/do-electronic-rust-protectors-work/
  3. Whatever64
    What is a "rust module" ?
  4. Whatever64
    The dealer said rubberized and gave me the name Cal-Tex. On line it says it is " A paraffin-based material, our Rust Inhibitor keeps moisture from corroding inner body panels from the inside out. Not only does Rust Inhibitor help reduce rust and corrosion, but it also helps protect against salt and humidity. "
  5. Whatever64
    That is what my dealer used...... it lasted 3 years and it is now peeling off...... They told me it was a one time treatment covered.... and now offered to use a rubberized undercoating no charge. Any opinions ?
  6. Whatever64
    GMC = RUST Both bumpers had rust through ( from the inside out ) within a year of ownership.... dealer replaced both and told me I should have waxed it. Had the frame wax recall treatment.... it lasted two years. found out it is a one time deal...... even if put on incorrectly. You can see where the pads from the lift contacted the frame before it had set up..... in a hurry ????
  7. Whatever64
    Are there fuses on a 2014 GMC Sierra for the left rear turn/stop light ? Thank You
  8. Whatever64
    I have thought about one also but not until they work out all the bugs...... In the mean time maybe an XD-E in .45acp
  9. Whatever64
    Anyone carry an XD-E in .45acp ? pros- cons ?
  10. Whatever64
    Model 60
  11. Whatever64
    Can't wait to hear about it.. and how you connect them OTRATT offers a 2 switch and 3 switch panel. The 3switch panel is about 3" and would JUST rn past the edges of the trim on the stock trim plate. The 2 siwtch plate is about 2.5" wide iirc and will cover the stock hole nicely and any hole I dremel to fit it in. This is a lot easier than sourcing the reaper/black widow switch pod or trying to engineer something to go into the cubby. I will post updates when all my parts come in. The OTRATT stuff is coming from CA to GA usps and I have a custom etching on one of them so.. it may take a week or 2 before I see it.
  12. Whatever64
    New headlight buckets and the dark spots are gone... Also got the first dent out of the way thanks to the dealer.....
  13. Whatever64
    Just had the new lamps installed along with the BCM flash. Lights are brighter, even the hi beams are good. Downside I now have dark spots in the light beam. Looked at the headlights and can see where there might have been condensation that has since dried and left residue on the inside. Back to the dealer tommorow Other than replacement any way to clean these ?
  14. Whatever64
    Who sells the wiring kit ?
×
×
  • Create New...