Jump to content

KillerOfMillers

Member
 View Profile  See their activity

  • Posts

    144

  • Joined

  • Last visited

 Content Type 

Everything posted by KillerOfMillers

  1. KillerOfMillers
    I'm looking into this kit, in the instructions it looks like it all goes together with out gaps. I'm having some difficulties understanding/picturing what you are describing.
  2. KillerOfMillers
    I have the Roll-n-Lock, and have no complaints, was easy to install, and no drilling required unless you want to drill into the bed for the drain lines. If you were near Houston, TX I'd make you a deal on it as now I changed my mind and want a SnugTop......
  3. KillerOfMillers
    https://www.roughcountry.com/gmc-leveling-lift-kit-1318.html?find=2019-gmc-sierra-1500-4wd-381260
  4. KillerOfMillers
    How much did you pay? They have a sell going on now and I'm tempted to pay for the pre-order.
  5. KillerOfMillers
    https://m.facebook.com/story.php?story_fbid=10158239894924465&id=223635099464
  6. KillerOfMillers
  7. KillerOfMillers
    4.79"
  8. KillerOfMillers
    Do you have any drone at highway cruising speeds. I ran a Borla XS on my 17 5.3 and it sounded ugly in 4cyl mode.....
  9. KillerOfMillers
    Stock suspension, 22x10 -18 w/ 33x12.50. Does have rubbing on mud flap, not major to where I think its going to rip it off but enough that I had to notch it out and clear 85% of it.
  10. KillerOfMillers
    That is what gets me, I did everything per your diagrams and the passenger side work fine. If you say it should work I'm going to have to check continuity and make sure I have a good connection between pins added. Believe me I checked everything repeatedly before I closed up the doors. It just got late and I was done messing with it at the time, I could not find the issue. The only pin I did not check for was the door jam connector. Thanks Roy
  11. KillerOfMillers
    tried searching the post but couldn't find anything specific, lots of pages...... 2017 GMC Sierra SLE Performed the DL8 to DL3 conversion. Started with passenger side and everything works fine, puddle and signal worked as they should. Completed the driver side and just the signal light works, no puddle lamp. Tested lamp, lamp is good. The only wires I did not run where the auto dimming circuits (from what I read does not affect my issue). Any guesses??? Checked and rechecked schematic and my wiring. My mulitmeter took a dump but I'm confident my crimps and connections are good.
  12. KillerOfMillers
    done.... not much difference in pics, but in person you see the difference.
  13. KillerOfMillers
    I picked them up for $327 out the door at 4wheelparts. Ordered on website, added googled coupon, and chose instore pick up.
  14. KillerOfMillers
    As it stands now, Bilstein's and 33s ready to be installed.
  15. KillerOfMillers
    I'll measure this evening and report back.....
  16. KillerOfMillers
    Will installing a GM Borla kit for a 6.2 on a 5.3 have any negative effect? I know its not a direct bolt on due to the size difference in ball flange. Just debating if I should just sell and get correct kit or cut and weld a correct flange on pipe.....
  17. KillerOfMillers
    Anyone using Rough Country HD2 boards?
×
×
  • Create New...