666

Putting the strut under a arm will cause a 2inch front drop and will make your alignment suffer. Why don't you just adjust your hangers from 2 inch drop to 1 inch drop?

Yes you can. That's the only way to go lower than 3 inch in the back. Also. If you did q flip kit you should be fine at 5 inch drop when it comes to towing but and lower will need helper bags.

Also, dropping the front with only strut and springs makes it really difficult to put back in alignment. I recommend getting 2 inch drop spindles and removing the drops springs from the strut. This will make your camber less aggressive.

Do the 6 inch flip kit. It will make it a lot more even

So I looked at my dads 16 silverado with stock hangers. I couldn't really see any differences. I heard that the 2007 and up silverados all use the same frame until 2018. Better yet I was able to find a cheaper set with better reviews. Amazon link: https://www.amazon.com/dp/B07QFDFCTK/ref=cm_sw_r_cp_apa_i_11t.FbB2185QH?_encoding=UTF8&psc=1 Truck photo:

Just get new ones, here are some cheap ones from Amazon, https://www.amazon.com/dp/B08JQM6M3P/ref=cm_sw_r_cp_apa_i_Bhs-FbY7HK281?_encoding=UTF8&psc=1

You ever did the maxtrac flip kit? Could you send pictures of your truck and the clearance between the frame and axle.

Damn, 900 for installation? Why was it so much?

Nice truck, could you take a picture of the clearence between the axle and frame? Also, how much was the kit and installation?

Hey isn't this your truck? https://www.streettrucksmag.com/lowering-a-17-chevy-silverado-1500/# Did you have any camber issues with this kit? Hiw much exactly did this lower your front and rear?

You used no camber kit right?

Oh thanks for the clarification but I was referring to caster. How does that affect my drive ability?

You sure you didn't get the 4/6 drop kit? Nice, so your camber is good and you didn't have use a add on camber kit? Also, what is caster and how does it affect your truck?

It aligned after the crash with no problems

Hey, I have a 2016 Silverado 4x4 crew cab and was wondering if I would have any alignment issues. I'm trying to go with a 3/6 but camber and alignment issues are what is really making me worried. The kit is a maxtrac which comes with 2 inch drop spindles, 1 inch drop spring, and a adjustable flip kit 5 to 6 inches of drop. Do any of you have experience with aligning a dropped 4x4? Here is the kit: https://maxtracstore.com/2014-2016-chevy-silverado-1500-2wd-4wd-1pc-drive-shaft-3-5-lowering-kit-maxtrac-ks331535/ Here is a picture of the truck(Note: this truck has been crashed before):