Jump to content


  • Content Count

  • Joined

  • Last visited

Community Reputation

2 Neutral

About MDgrey17

  • Rank

Profile Information

  • Name
  • Location
  • Drives

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Are these the standard halogen tail lights or the Denali led? Sent from my iPhone using Tapatalk
  2. Ok, thanks. I’ll check it again. Sent from my iPhone using Tapatalk
  3. So we had some major rain Saturday as I was driving to work. Everything was normal on the drive in. After work, as I normally do, I remote started my truck, only to find out it hadn’t started. I started up my truck with no issues but the CEL was on. DTCs P0098 P00F4 P2199 popped up on my diagnostics on my head unit (Alpine restyle). For home, the truck seemed to run fine except when I parked on my inclined driveway started to idle funny. Looked up the codes, they show to be for the air intake sensor/maf combo unit. Tore apart the intake, inspected the maf, no issues, water, etc found, everything looks clean. Looked at plug and wiring harness, no noteable issues found. Upon further inspection, I found a plug hanging underneath on the drivers side at the frame right in the middle of the driver front and rear doors. It isn’t used bc it has a dummy cap but I’m assuming it’s for either transfer case or does fuel, neither of which I have. The sheathing has been pulled back and the cooper wire was showing on multiple wires. I fixed the wiring but still have the double codes. Ive reset through the head unit which I’m able to do with the Alpine as well as pulled the negative several times and the codes are still there. The only difference now is that the truck runs fine and doesn’t idle funny or stutter. I’ve looked for schematics, etc and haven’t come up with much to help me troubleshoot. I have ordered a new air intake sensor, just in case, but I’m not sure that’s the issue. Any help, advice, schematics would be greatly appreciated. Sent from my iPhone using Tapatalk
  4. I need the rubber insert left and right that goes in between the upper tray and lower console. See pics below. Let me know what you’ve got and how much you want? Thanks for your help. Sent from my iPhone using Tapatalk
  5. HUGE shoutout to Phil and all his hard work and time making these harnesses for us. I finally installed my console yesterday, watched both Phil’s vid and the one above for removing the passenger seat, both are extremely helpful. Had a few hiccups but Phil’s immediate responses and OUTstanding customer service helped me resolve the issues and now I have a fully functioning console. Thanks again to Phil and other members who have posted info to make this swap so easy. Sent from my iPhone using Tapatalk
  6. Shout out to pgamboa. Replaced dl8 with dl3 mirrors I picked up off of CL, bought switch and harness from Phil. Everything works perfectly and Phil’s customer service is above par. Sent from my iPhone using Tapatalk
  7. I have one that I bought through a programmer on eBay and ran it until I did the Alpine upgrade on my truck. Here’s a pic from when I did the upgrade. Sent from my iPhone using Tapatalk
  8. Did you ever find a io6 2.5 hmi? Sent from my iPhone using Tapatalk
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.