Jump to content

PabloK

Lifetime Supporting Member
 View Profile  See their activity

  • Posts

    285

  • Joined

  • Last visited

  • Days Won

    3

 Content Type 

Everything posted by PabloK

  1. PabloK
    drive up to MN! too expensive to ship!
  2. PabloK
    2019 AT4 fully loaded.. 43,000 miles dealer gave me a check for 56k! handing her in tomorrow. will order a 2022 when supply levels out. BUY LOW SELL HIGH!!!!!!!!
  3. PabloK
    i spent months dialing in the perfect setup for such application you want 285/55/22 Nitto Ridge grapplers they measure out at 34.61 inches. zero fitment issues or rubbing on stock at4 I have 32,000 miles on my set and they still have over 50% tread left.
  4. PabloK
    Got one in hand Install starts today Sent from my iPhone using Tapatalk
  5. PabloK
    Here's my build... starts June 1st! Front doors -C7-100ct -C7-350cm -C7-650cw -Audiocontrol 6.1200 DSP Rears -C5-650x -Audiocontroll 4.300 everything else -JL StealthBox 2 12TWB -XD600/1v2 -large amounts of door soundproofing -AmpPRO4 GM Interface1 -AmpPRO4 Fiber Optic Output -Audiocontrol ac-bt24 Bluetooth adap -JL Bass knob
  6. PabloK
    truck rides better with a sled in the back, its great. i like this ramp, the big padded clamps dont dig into the tailgate and scratch it like several others i tried. built in safety strap with clamp is nice too Caliber-CBR-13526-PRO
  7. PabloK
    Damn sorry I’m sure they will come out soon Sent from my iPhone using Tapatalk
  8. PabloK
    There’s 50 on eBay Sent from my iPhone using Tapatalk
  9. PabloK
    Not yet.... was sleddin up in the UP all week... got nothing done... But the AT4 is a beast in the snow! Blizzaks are like glue! ! Sent from my iPhone using Tapatalk
  10. PabloK
    Love it! I’m getting there slowly lol Sent from my iPhone using Tapatalk
  11. PabloK
    1. You have to remove the wheel arch moldings at least half way to reach a bolt towards the top of the front Valance. 2. There are push clips and body clips everywhere. The hard ones are where the valance meets the front fender as its really hard to get the trim tool in there 3. There are to clips that hold the fog lamp air intake to the Frame, 2 clips and 3 U-Body clips for the trim by the headlights, 3 push clips across the front and 4 body clips as well. 4. You need two people to support the valance until you have the clips off so 1 side wont twist and fall 5 there are 3 bots on the bottom of the grill (that I though or think hold it on as well) 6. Replace the valance by starting on 1 side, do not do the middle section till the end as the trim that goes up to the headlights takes some fiddling to get right and with the bottom clipped you wont have the clearance to get them all aligned. The grill lifts up with a bit of a tug. Sent from my iPhone using Tapatalk
  12. PabloK
    It’s a very nice deep gloss. Hopefully install it sooner than later! Sent from my iPhone using Tapatalk
  13. PabloK
    Quality is good Just opened her up Sent from my iPhone using Tapatalk
  14. PabloK
    Yup I’ll open her up shortly here... Sent from my iPhone using Tapatalk
  15. PabloK
    I have it in my garage Pics coming Sent from my iPhone using Tapatalk
  16. PabloK
    Oh yea, one song makes my HUD vibrate to the point I can’t read the numbers Sent from my iPhone using Tapatalk
  17. PabloK
    Does the truck have internet? Might need to make a hotspot with phone? I could be way off Sent from my iPhone using Tapatalk
  18. PabloK
    Yea odd Here’s mine Sent from my iPhone using Tapatalk
  19. PabloK
    Sorry didn’t mean to get basic, I dont know how much folks know about this stuff...I got mine from same place.... Maybe you got a dud? Buy a 2nd unit from someplace with a good return policy, swap the amp. Otherwise... do you have the correct bass knob? Have you done the fade test to see if it’s clipped in to ffront passenger speaker? Sent from my iPhone using Tapatalk
  20. PabloK
    Are you listening to music from the 40s? The “top tier” Bose system is barely acceptable for this $ range and it being the year 2019. The $450 sub makes it significantly better from a bang for your buck point. Solid critical feedback as well “waste of time”? Sent from my iPhone using Tapatalk
  21. PabloK
    Sent from my iPhone using Tapatalk
  22. PabloK
    That’s 100% for JL audio stealth box not this system. I Had the issue with my SRT and ended up ripping the SC module out. Also noise cancelling doesn’t do shit, it’s mainly to block out odd noise from engine going between 1-8 cylinders., Which already sounds like shit. Sent from my iPhone using Tapatalk
  23. PabloK
    Did you install it? Do you have experience with kind of stuff? It’s not noise canceling. What’s your source? iPhone hardwired is best, get song with bass (Ini Kamoze - World-A-Music) is often used in audiophile community. First is it firing? Jam your hand under there and you can easily feel the sub and how hard it’s hitting. Look over your wiring, triple check. Put the dials back in orig config. That’s critical Make sure the system is off and no power before plugging in bass knob or it will throw off entire systems gain. There is nothing different between my AT4 and your Denali that would affect this. The sub, when properly installed, shakes my truck. It’s either installed incorrectly or your amp is dead. Sent from my iPhone using Tapatalk
  24. PabloK
    Your looking at $3300 in parts to do that setup properly. (Not some hillbilly amp from bestbuy). Plus your average joe will need it installed which is easily $300-500 Who’s going to dial in the tuning? Hard to find a installer that gets the mic out and creates a specific DSP file for you. Then to Run that setup with our $5 paper cone Bose speakers? If you have money to burn, yea it’s a solid setup, the box is overpriced though.. and you’ll overpower and drown out your mains.. for $450, find me a factory tuned class d 32bit amp, sub, and sealed box with a factory fit. And I’m not taking a dump on JL... I have 3 stealth boxes with w6s and a 8inch w7 paired with a 13w7 in my boat.. If you just need that kind of bass, Get a hertz or w7 10 inch, custom built pine box, sealed, best amp you can afford (if JL, no less than $800). That will acoustically sound better, and hit harder than those 2 shallow w6s Sent from my iPhone using Tapatalk
  25. PabloK
    yea RC setup is clean. RI is big money... agree... quality is there though..
×
×
  • Create New...