Jump to content
  • Sign Up

LED Conversion

RDretired
 Share

Recommended Posts

RDretired New Member

RDretired

Posted
Posted

I am installing a deck on a 2020 3500 HD using the existing tail light wiring harness and installing some different LED tail lights. Everything physically works except that I get the rapid flash  and dash pop up saying the signal / stop circuit is not working. I am using 2 LED lights each drawing 198ma for a total load of 348 ma.  I have tried the 6ohm load resister with little change. Can any one tell me what the circuit load should be, or how the are getting that dash warning to disappear

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    249.2k
    Total Topics
    2.6m
    Total Posts

  • Member Statistics

    340,410
    Total Members
    8,960
    Most Online
    DMann
    Newest Member
    DMann
    Joined

  • Who's Online   5 Members, 0 Anonymous, 1,678 Guests (See full list)



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept