Jump to content

2017 Silverado 2500 Cargo light camera and switch

Troy Harris
 Share

Recommended Posts

Troy Harris New Member

Troy Harris

Posted
Posted

Hello. I would like to add a cargo light backup camera and instead of having a separate switch controlling the camera, I'd like to tap into the cargo light switch.

 

Any recommendations on a good cargo backup camera?

 

Can I use the cargo light switch to control the camera? If so, how?

 

Thanks!

Buckwild27 Enthusiast

Buckwild27

Posted
Posted
On 3/4/2023 at 8:28 PM, Troy Harris said:

Hello. I would like to add a cargo light backup camera and instead of having a separate switch controlling the camera, I'd like to tap into the cargo light switch.

 

Any recommendations on a good cargo backup camera?

 

Can I use the cargo light switch to control the camera? If so, how?

 

Thanks!

It might be easier to just do the video rearview mirror mod. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Grumpy Bear
      Slate Electric Truck

      By Grumpy Bear · Posted

      Most say the oil temperature needs to above the boiling point of water to rid it of moisture and long enough to dry it. Many think that is about a hour at 212 F or more. Those people have never line dried cloths in a Midwest winter. Leave a pan of water sitting on the counter and eventually it all evaporates. So heat drives the time it takes. Water in oil under 175 F, the Nitration initiation temperature, is a minimum then for temperature and samples I've done that use Karl Fisher method say about a hour (in a healthy well tuned motor) over 175 F will dry it to under 800 ppm. Low enough to not be much of a factor. Motors with weak rings will take longer and the colder the air temperature the longer it takes.   On a cold motor there is also the condensation temperature. Blowby gases that contain moisture are subject to that cold cylinder wall, like sweat on a glass of ice tea. But also subject to the Law of Partial Pressures. Wear studies by GM and the DOD  indicate wear is a real issue below 85 F and a concern to 140 F but doesn't become a minimal factor until about 160 F. You know this intuitively when you see water vapor exit the exhaust pipe until the system gets above the dew point. It isn't magic, it's physics and it fascinates me. I know you didn't ask but....I over share sometimes. 😉    You keep the Camaro's high and tight.  
    • asilverblazer
      Slate Electric Truck

      By asilverblazer · Posted

      Move further away.   Benefit of living out - none of our cars get short cycled, plenty of warm up time.   Curious how much time/temperature it takes to drive moisture/condensation out of the engine?
    • diyer2
      Transmission Temperature Hitting 220s

      By diyer2 · Posted

      Switch a a 100% synthetic trans fluid, Amsoil works for me.
    • DustMcGrath
      Transmission Temperature Hitting 220s

      By DustMcGrath · Posted

      First of all sorry, I know there are a ton of transmission temperature threads...   My truck is a 2025 LZ0 High (10l89 10-speed) High Country with NHT max trailering package. The NHT package is supposed to have "enhanced cooling."   Normally the trans temp sits around 200. It seems like with any real stress it quickly jumps into the 220s (for example climbing a grade unloaded at lower speeds). I haven't towed much with this truck, but I'm concerned if it gets this hot unloaded.    I've tried a few different things to keep the temps down (tow/haul mode, sport mode, low range when that makes sense) and nothing seems to affect it.    I'm curious if others are the same behavior or if anyone has found techniques to keep the temps down. It seems like it just can't handle reduced airflow at lower speeds, even with relatively light loading.    Thanks!      
    • cautious optimist
      2027 3.0 l Duramax

      By cautious optimist · Posted

      I'm at 105,000 miles on my baby Duramax. No issues yet. I hit 31 mpg's traveling through hilly terrain to a project in Colorado. I will buy another 3.0. I'm not concerned.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...