Jump to content

Wait4me Tune Installed In A Nbs


Recommended Posts

Posted

Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :lol: Here is what I went with.

 

AFM disabled

100 % TM gone from ECM, and 84 % removed from TCM

Performance towing tune 89 Octane (Timing advanced 4,8,12 degrees since it changes on the fly)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

Top speed limiter gone/

Rev Limiter raised.

 

The best bang 4 the buck. $125 charged for tune + 10 for shipping. $135 Postal money order sent. :crackup:

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :smash:

Posted
Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :smash: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

Posted
Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :smash: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

 

 

5 days it took for me to get my modules back. I purchased new ones, and had him program those. I have my stock one's in my safe. :lol:

Posted
The Tm is 100% gone? I didnt know you could do that.

And I quote " 100% of TM gone from the ECM", and "84 % removed from the TCM" Not 100% removed. My bad.

He can remove all if requested. :crackup:

Posted
The Tm is 100% gone? I didnt know you could do that.

And I quote " 100% of TM gone from the ECM", and "84 % removed from the TCM" Not 100% removed. My bad.

He can remove all if requested. :smash:

 

 

Sorry didnt see that at first. :crackup:

Posted
Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :smash: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

 

 

5 days it took for me to get my modules back. I purchased new ones, and had him program those. I have my stock one's in my safe. :lol:

 

 

Where did you purchase the new ECM and TCM? I was under the impression these were not yet available for the NBS! How much were they (if you don't mind me asking)?

Posted

2663605_7_full.jpg

Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :smash: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

 

 

5 days it took for me to get my modules back. I purchased new ones, and had him program those. I have my stock one's in my safe. :lol:

 

 

The lady on the phone told me they didn't have the new ones for my truck yet. She said I'd have to send mine or buy there software. Software is over 1000 bucks. Did you get yours from the dealer or something? I just sent my $400 Hypertech back today. THat was crap. Double crap!!

Posted
Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :smash: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

 

 

5 days it took for me to get my modules back. I purchased new ones, and had him program those. I have my stock one's in my safe. :lol:

 

 

Where did you purchase the new ECM and TCM? I was under the impression these were not yet available for the NBS! How much were they (if you don't mind me asking)?

 

I purchased them from the dealer. Since I purchased 2 new vehicles from this particular dealership (Camino real GMC in OC. Yukon XL slt for Wife) the Salesmen got me the modules at cost. I gave $350 for both.

Posted
2663605_7_full.jpg
Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :smash: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

 

 

5 days it took for me to get my modules back. I purchased new ones, and had him program those. I have my stock one's in my safe. :crackup:

 

 

The lady on the phone told me they didn't have the new ones for my truck yet. She said I'd have to send mine or buy there software. Software is over 1000 bucks. Did you get yours from the dealer or something? I just sent my $400 Hypertech back today. THat was crap. Double crap!!

 

 

 

I bought mine from the dealer. I agree Hypertech is trash. I felt the same way with my superchips handheld unit that I had until last week. I sold it on ebay :lol:

Posted
The Tm is 100% gone? I didnt know you could do that.

And I quote " 100% of TM gone from the ECM", and "84 % removed from the TCM" Not 100% removed. My bad.

He can remove all if requested. :smash:

 

 

Sorry didnt see that at first. :crackup:

 

No problem brother :lol:

Posted
Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :lol: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

 

 

5 days it took for me to get my modules back. I purchased new ones, and had him program those. I have my stock one's in my safe. :crackup:

 

 

Where did you purchase the new ECM and TCM? I was under the impression these were not yet available for the NBS! How much were they (if you don't mind me asking)?

 

$350 for both from the dealership. :smash:

Posted
Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :lol: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

 

 

5 days it took for me to get my modules back. I purchased new ones, and had him program those. I have my stock one's in my safe. :crackup:

 

 

Where did you purchase the new ECM and TCM? I was under the impression these were not yet available for the NBS! How much were they (if you don't mind me asking)?

 

$350 for both from the dealership. :smash:

 

Then how much for the tune?

Posted
Well I got my ECM and TCM back from Jesse yesterday. I installed them this morning and let me tell ya, the Vmax has really come to life. Finally from a dead stop with the traction control turned off I can burn rubber. (no rolling smoke but some rubber left behind) No more active fuel management (AFM) it has been disabled. She stays in V8 mode all of the time! (yes) :lol: Here is what I went with.

 

AFM disabled

100 % TM gone

Performance towing tune 89 Octane (Timing advanced 2-3 degrees)

Transmission shift points stock with psi increased.

WOT and 1/2 throttle 4 second delay gone.

 

So far so good 60 miles into it! Wait4me tune by Jesse Bubb :crackup:

 

How long were you w/o your truck.

 

 

5 days it took for me to get my modules back. I purchased new ones, and had him program those. I have my stock one's in my safe. :crackup:

 

 

Where did you purchase the new ECM and TCM? I was under the impression these were not yet available for the NBS! How much were they (if you don't mind me asking)?

 

$350 for both from the dealership. :smash:

 

Then how much for the tune?

 

 

$125 + 10 for the shipping back to you. :cheers:

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...