Imperial91

If you’re going to do that, just to inserts. They sale some to cover your black trim. It’s close enough to the LTZ grill and cheaper. If you really wanna swap out the grill, do it for a High Country grill. Bigger difference, cost just as much the LTZ. Sent from my iPhone using Tapatalk

A little before and after[emoji7] Sent from my iPhone using Tapatalk

Went from 24”s (top) to 22”s (bottom), no more rubbing haha! Sent from my iPhone using Tapatalk

Most drops use an adjustable strut to go lower combined with drop spindles, so I don’t see why not. I probably wouldn’t go to the top ring though haha! Are those Trail blades? Looks like an aggressive sidewall for a lowered truck. Sent from my iPhone using Tapatalk

McGaughy’s adjustable kit Sent from my iPhone using Tapatalk

I’m running 295/35/24 on +25 offset. I rub on a 3/5 drop if that’s what you were wondering? Sent from my iPhone using Tapatalk

2016 with McGaughy’s adjustable drop set at 3/5. Just had the 24s put on today. Wheels are 24x10 +25 offset on 295/35/24 tires. Noticed some fender liner rubbing in reverse, may have to mess around with it to see if I can zip tie for a quick fix. Next on the list is to remove the side steps... was lifted before haha. Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

I don't have the Corsa setup on mine. The tips however are similar, I have them going out to both sides of the truck, with a Carven muffler. I love the way it sounds. Sent from my iPhone using Tapatalk

Yesterday I added 3" lift spindles to my already bilstein 5100's on the top setting. I drove around hauling an invisible trailer and got an alignment. The ride itself is actually not bad. It's firm, but it's a nice firm. Today I replace stock blocks with blocks to raise the rear 2 inches. I haven't measured it yet, but the stance looks a lot better than before. Sent from my iPhone using Tapatalk

I'm almost thinking if I would have went with a 3 inch level they might clear. Sent from my iPhone using Tapatalk

Not my picture but it rubs right here... it's right before full lock, the edge of the tread brushes against the felt. There is also a small bolt there holding the factory plastic moldings it rubs one while passing by it. In this picture the person did a little trimming there Sent from my iPhone using Tapatalk

Out with the old... In with the new! 20x10 Full Throttle -24 offset 33x12.5x20 Atturo Trail Blade XT 5100's on top setting in the front. Rubbing rear end of fender well. Not too bad. Debating about going higher or getting slightly smaller tires. Sent from my iPhone using Tapatalk

GM CK948 wheels you can find them online... pretty pricey from GM. I bought them used from someone locally. Sorry for the late reply. Sent from my iPhone using Tapatalk

Well damn. That looks nice haha. It looks a little funky with the 33's. if I lower I don't know if I will keep same wheels and go with different tire or switch wheels to maybe some 22's. The current wheels are 20's. Sent from my iPhone using Tapatalk