Jump to content

Custom Tune for E85?


Recommended Posts

Posted

Its my understanding that E85 will result in lower mpg but is anywhere from 100 to 105 octane. Would a custom tune (wait4me) be able to improve on this. Its my understanding that Jesse can tune for 91-93 octane and get nice MPG improvement as well as added HP. Would running E85 (with a tune) get you the same results as maybe running 87 octane (MPG wise)but with the added benefit of higher HP?

It is also my understanding that FlexFuel vehicles have larger fuel pump and larger injectors, diff sensors. Would it be possible to open those things up with a tune when running on regular gas? My 5.3 seems to be a little quicker stock than most and wondering if the larger fuel pump, injectors would be the difference?

 

Just some thoughts I have been pondering...

Posted

I'm not sure if you can get a tune specifically for E85 fuel. I did have a westers tune on my 03 tahoe and I was still able to run E85 in the Tahoe. I had the same basic results with the E85 as regular fuel. I had a 93/91 hot tune. E85 in general got me worse fuel mileage then 93 octane but the tune improved my E85 mileage from 12 to about 14-15 and my 93 octane mileage from 15 to about 17-18. So it will help your mileage but I don't know if they did a tune specifically for e85 if they could make it even better. My hunch is yes they could me more aggressive with the timing and fuel changes because of the high octane if you are running only E85 but you could severly limit the flexibility of the vehicle because you could do serious damage (detonation) if you had to use regular fuel. And E85 still isn't available in all markets. Best bet would be to call your programmer of choice. Based on everything I've read it sounds like all the major programmers (wester, nelson, Wait4me) are very helpful when your trying to pick the best tune for your needs.

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,914
    Total Members
    8,960
    Most Online
    AidenVorpagel
    Newest Member
    AidenVorpagel
    Joined
  • Who's Online   1 Member, 0 Anonymous, 1,118 Guests (See full list)

  • Latest Articles

  • Posts

    • Thanks newdude!  By the time manual selection is needed, I'm probably too much of a control-freak to depend on the transmission sensing braking to activate automatic downshifting.  I would be anticipating the situation and already be manually downshifting.   This truck replaced a 2004.5 LLY diesel with the Allison 5-speed.  Putting it in T/H made noticeable differences (when the torque converter locked, upshift points, downshift behavior).  On this 2024 gasser with the 10L1000 I haven't been able to detect much, if any, difference.  Ok, I can never tell now when the torque converter locks up.  But I also don't notice differences in shifting.  For downhills, I've probably already manually downshifted by then anyway.  Since it's also more awkward (than the 2004.5) to engage/disengage I don't even bother.  Or maybe it doesn't really matter with just a 3k lb. camper in the bed?   Thanks also for the list of reasons the charging system might select various voltages.  However, what I am seeing doesn't fall into any of those categories.  It very definitely, and very consistently, rises after coasting/braking.  Maybe not immediately, but not very long after coasting/braking.  Very consistently drops voltage when no longer coasting/braking.  It might also be interacting with the camper battery charging (I might disconnect the camper and see if it changes the charging behavior).  I also need to recheck turning on headlights for when I want to force it to charge the camper.   Another JR, in June I converted the camper to LiFePO4.  Since it's not a good idea to try to charge lithiums directly using truck, I installed a Victron Orion XS DC-DC charger (which BTW is AMAZING!!).  Being cheap, I only had to buy that one item (besides the battery, of course) to do the conversion.  The camper OEM 120v battery charger (only 19 years old and works perfectly) and the truck feed the input to the DC-DC charger (not at the same time).  But I didn't want the camper charger feeding back to the truck so I kept the old separator.  I considered replacing the separator with a 30amp diode but that means more work and might add another 1/2 volt drop.  One thing that surprised me was the voltage drop over the long 10awg wire run, so I can only charge smoothly at 8 amps (because the DC-DC charger is completely configurable).  Another reason I don't want an added voltage drop with the diode.  I might also be a little lazy but all this work is being done under the sink with a small cabinet opening.    
    • apparently CA smog is (or at least was)  checking that the vehicle is using the oem and/or a ca smog approved tune, so I expect you'll fail inspection doing it.
    • yes, leaking exhaust will mess up o2 sensor readings, which in turn messes up fuel trims.
    • 286,740 Mile Services   8/6/2026   New AC Compressor. Refrigerant oil and dye, evacuate and charge system.  New exhaust system from cat back.  New Iridium plugs plus replace #3 coil Repair/rewire headlamp wiring (passenger side) and replace all forward bulbs. Polish lenses of both assemblies.  Pull rear rotors, clean and adjust parking assembly. Inspect, clean and grease front calipers. Check pads and shoes.  4 wheel power bleed of brake system. Dot 4 Reset idle speed 50 rpm higher New Serpentine belt.    Will need new pads in the rear in about 5K more miles.    Tax Title and License out the door just short of a grand.    AC clutch had bitten the dust. 1 year warranty on the pick and save replacement. Thing will make a Polar Bear cry Uncle.  He spent quite some time on the wiring. It was in the harness and he does nothing half. I got off cheap. I have considerable more light down the road. Sylvania Silver Star replacements.  Gas seal between the porcelain and shell of plug #3 was blown, cooked the coil. That was the cold miss.  Love the new exhaust. I can sneak into the neighborhood again.  Nice to have a working parking brake again. Belle Tire never got it done. That was disappointing.    This was one of her bigger bills and still way cheaper than a payment even given the oil consumption. This thing cost me under a hundred a month in repairs and normal routine costs. What is my incentive to replace it? 🤔           
    • hello I recently bought a 2012 gmc 1500 with a 5.3 and have a AFM disabler on it I'm interested in doing a cam but I'm worried if I remove the AFM system I will fail smog does anyone have info if they are able to detect that or a work around to it (not talking about hot smogging) please let me know thank you  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...