Jump to content

Recommended Posts

Posted (edited)

I tried searching, but didn't find anything. Since a NNBS wiring harness isn't available, I wonder if the standard cruise control harness can be modified to accept the radio wiring. I looked at my harness, and it has 3 open slots in the plug to the SIR coil, so can it be as easy as picking up a pigtail and adding the wires to the other harness? Could any of you who have a harness handy check it out and let me know what wires go to the radio controls and where on the plug they go?

 

Thanks!

 

Galen

 

P.S. Maybe some pics of the connectors would be helpful

Edited by Galen
  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

Posted

Damn, nobody has a harness out of the truck right now? I guess I will have to wait until I head back to my parent's house and pull apart my father's new truck to trace the wiring!

 

Galen

Posted

I have a used gray avalanche steering wheel with the controls that I'll look at when I get home.

Posted

The SIR coil connector has letter designators for each of the wires as follows:

 

A - Grey

B -

C - Light Green

D - Brown

E - Pink w/Black stripe

F -

G -

H - Dark Green w/White stripe

J - Tan

K - Black

 

The connector to the radio controls is not labeled, but looking at it from the top/front of the steering wheel the wire colors are: Black, Brown, Pink w/Black stripe, and Light Green. Your Cruise control wires should be (not in order) Grey, Brown, Pink w/Blk, Dark Green w/Wht, and Black.

 

I don't know how the controls work with both sharing three common wires but it does????

Posted

Wow, I thought that they would go to the open slots and just have a wire or two shared...guess I was wrong! Thank you so much for checking this out for me! Looks like it should be fairly simple to tap into those wires and add the buttons without buying another wheel!

 

Galen

Posted

I just bought a steering wheel w/ audio controls. After I read this post I figured I would take some pics while I had the wheel apart cleaning it. Hope this helps along with Gil85's post. The 2 smaller plugs are for the switches, the Black w/ 4 wiresis for the audio controls and the gray is the cruise. Both are from the top of the plug.

post-42802-1249580543_thumb.jpg

post-42802-1249580543_thumb.jpg

post-42802-1249580543_thumb.jpg

post-42802-1249580543_thumb.jpg

Posted

Have to work on sizing images, but here is the black plug. If you already have cruise then you can see the wires going to that plug.

post-42802-1249580864_thumb.jpg

post-42802-1249580864_thumb.jpg

post-42802-1249580864_thumb.jpg

post-42802-1249580864_thumb.jpg

Posted

Thanks for the pics...those make a world of difference. I will take pics and post results when I get my controls ordered and installed!

 

Galen

  • 2 weeks later...
Posted

Hi all. I just purchased a 2009 Silverado 1500 LS and like to know if I can add steering wheel controls for radio and if possible for cruise control later.

Thanks

Posted
Have to work on sizing images, but here is the black plug. If you already have cruise then you can see the wires going to that plug.

 

 

AHHHH!!! i used to make those steering columns...i worked at delphi in michigan...i cant escape that place! ha ha.

 

on a side note, you can modify them. i dont know the exact way to do so, but i know you can (having built them for 2.5 years...ya learn goods and bads about them). like the fact that half the columns are made by drunk people. :D

Posted

Joe, welcome to the board! As far as adding cruise and audio controls, you may be better off starting a new post about how to add them. The steering wheel change/ audio control addition is mainly for a truck that came with cruise control. To add the cruise, I imagine (but am not sure) that you would have to add a wiring harness to the column and a BCM programing/replacement. Once again, a new post would probably get the traffic you need to answer your question.

 

Galen

 

P.S. Thanks everyone for your help. I ended up getting a good deal on another steering wheel, so I didn't have to splice any wiring like I first thought I would have to.

Posted

Glad all worked out for ya! I just added the controls myself and love them. Had em on my 07 but my 09 didnt come with em! Didnt think i would miss them. I thought wrong :D

Posted

Thanks for the insight. It looks as if I won't be able to or at least at this time as GM will not allow the BCM to be reprogrammed to allow cruise to be turned on in vehicle that came without. DAMN, Never thought I'd miss it either. :D

Posted

Man that sucks! I mean really whats the big deal. Sounds like they just dont want to mess with it. I already had the cruise. Anytime I have taken my truck to the dealer to have something programmed they have never given me the line of Oh we cant do that or anything along those lines.

 

 

Well maby someone here has added cruise to one of these style trucks and can help you out!

Posted
Glad all worked out for ya! I just added the controls myself and love them. Had em on my 07 but my 09 didnt come with em! Didnt think i would miss them. I thought wrong :lol:

I have a 2009 chevy silverado. The cruise control buttons are on the stearing wheel. I would like to add the radio contros on the stearing wheel. Do I need to add wires to the stearing wheel column or are they already in place. And any idea where I can buy the radio control buttons.

Thanks for your help

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined
  • Who's Online   2 Members, 0 Anonymous, 1,453 Guests (See full list)


  • Latest Articles

  • Posts

    • My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • I have 2 choices. 
    • Do you have access to BP fuels? Some stations have Silver 91 E-0 priced the same as their 93 E-10.  There is a local Marathon with 90 alky free for $6 a gallon but I go down the road to BP for $5-ish. They also have a 100 E-0 but that stuff is $10 a pop. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...