Jump to content

Recommended Posts

Posted
Just now, rav3 said:

Good info. I have a Range Disabler & I have to remove it a week or so before get it inspected (in NC) in order for it to pass inspection. Maybe I should contact them for an update. What year is ur truck? Mine is a '17 5.3 6 speed

Mine is a 2016 5.3 6 speed. I don't know how old mine was but I had been using it for several years. It couldn't hurt to reach out to them. Supposedly the new version runs in a more stealth mode. I only contacted them because of the failure but they may just do an upgrade just because. Here is what I found in their FAQ

 

"HOWEVER, the latest firmware (8.6+) has a more "stealthy" mode and is invisible, so it DOES NOT affect the OnStar report for most vehicles most of the time. HOWEVER, there may be a case where the Onstar hits the vehicle when running or driving, and at those times it MAY give an error"

 

Although this is discussing the monthly OnStar diagnostic report, I think it also applies to the sensors from my experience with it.

Posted
On 11/24/2024 at 10:18 AM, Grumpy Bear said:

 

My 2015 has 185,000 miles on her. Original brakes and yes, including vacuum pump and works like a dream. I even declined the ABS reprograming. 

 

The secret is clean vacuum pump screens and they stay clean when oil is changed often enough to prevent precipitation of oxidation, nitration, lacquer and varnish products AND/OR use an oil with enough solvency AND dispersant to hold them in SOLUTION for the current oil change interval. There is also the environment to consider. How it is used. I do all three. 5K (shorter) and a high solvent oil (Ester bearing). Not a short haul, stop and go machine and not used much in the winter months.  

 

As this is/was a common issue for original equipment small screen pumps it aught be self evident that the recommended oil license and suggested oil interval is inappropriate. Dexos1Gen2/3 and 7,500 miles. The OEM cure was a pump with a larger mesh passing screen. Also bearing witness to obstruction as the secondary issue. The oil class and interval the 'root cause'. One to expensive for the OEM to 'Fix" with a requalification. 

 

These same fine mesh screens are also present in the VLOM and under the oil pressure switch.  Of these three only the pressure switch is easy to access and a routine replacement on say 40 to 50K mile intervals (replacement) will give one a visual cue as to the effectiveness of you particular situation. That is, even the OEM oil and OCI MAY be effective IF the engines environment is oil friendly. Long haul highway miles in a warmer climate as the bulk of it's existence for example.

 

Let me get my 'blow back' popcorn out:

 

 :lurk: 

 

Thanks for waiting. 

 

 

After scouring various sites and articles, this is by far the best 'simple' answer I've seen yet and makes perfect sense.  I don't do extended OCI, but also do a lot of very short trips and in a colder winter climate. So, sounds like frequent OCI is the key here. Thanks for the insight.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,972
    Total Members
    8,960
    Most Online
    Whit.the.COB
    Newest Member
    Whit.the.COB
    Joined
  • Who's Online   4 Members, 0 Anonymous, 1,242 Guests (See full list)

  • Latest Articles

  • Posts

    • I did the new thermostat after doing a 'flip' for a year. Runs as cool one way as the other in the summer but in the winter there is a bit of a floor. Yellow with the new 70 C thermostat. My data over the life of the unit to date. Still need more cooler. Anyway that floor helped both winter fuel economy and shift quality in the winter. I found it a good balance.       
    • Evan Williams Bottled in Bond   So pouring the last of a bottle of Evan Williams Black label last night I set off the the state store for a refill only to be denied the by an empty shelf. Rats.    What the did have was a bottle of Evan Williams Bottled in Bond. 100 proof. Hum, a few bucks more but a known distiller. Lets have a swing at it. ( I have before )    Cracked it open and pour a serving over ice. Hum.... more heat, yes. More alcohol naturally. But the barreling not the proof brings the taste and this one came up short.    Oh is was familiar but the heat ran the barrel over like a Peterbilt runs over a squirrel. Could use a heavier toasting of the oak me thinks or perhaps a longer barreling. Who knows. But what I can say is ice or a water back isn't the answer. What kills one kills them both. Sad. It is a pleasant drink....if you have little to compare it to.  
    • I've had exactly one set of Bridgestone. Lasted five year and 125,000 miles and had I known better 15oK would have been a cake walk. I would have bought a like set had they not tripled in price since the first set. I removed them at said mileage with 5/32" remaining in dead even wear all four. They were fuel efficient, quite, comfortable and predictable.    Early on I got a very good alignment checked at least once a year, sometimes twice; kept the tires properly inflated, balanced and rotated. And I've found that many a tire issue can be avoided with great maintenance practices. Lot's of tire dealers will do rotation and balance (simple) for free for as long as you own the tire they sold you so no excuse not to.    Bead prep, alloy integrity and stem health have a huge impact on inflation stability. There are more mountings done poorly that perfectly. Finding a good tire guy is gold and as important as finding a tire you like.    That 3X price increase now two sets of "other tires' later is starting look like a bargain.      Bad maintenance kills more tires than bad tires. 
    • Atlas, you kill me As aggravating as a project like this can be you have been unable to hide your fascination with learning and using that angst against this beast like a Ninjitsu Master. It amuses you, admit it now.      BTW, love your writing style. 😉       
    • I gotta say, I'm enjoying your narration. The troubles you've been having are amusing as you describe them. It's good to see that you're finally getting some satisfaction out the old beast though.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...