Jump to content

Looking To Buy Some Bed Rails

gmercury

Recommended Posts

gmercury Enthusiast

gmercury

Posted
Posted

I am looking for some tubular bed rails. I installed an access low profile bed cover and want some advice on some rails. They would basically be for looks. What are some good brands? Chrome or stainless? I think either would look good as I already have chrome steps. Any pics would be great. I have a 2010 etx cab reg bed!

chakis24 Senior Enthusiast

chakis24

Posted
Posted

i like the putcos i bought because they still have 1000 pounds of tie down strength at each corner, most other brands only allow for 500 pounds. mine are also black powder coated stainless steel (which were discontinued- i actually bought the last pair on amazon. site said one left, and after i bought them i looked back and it said out of stock and 4wheelparts didnt have any). the steel tends to be cheaper than the chrome i think, and it wont rust.

 

 

pic of mine:

 

getattachmentaspxiv.jpg

gmercury Enthusiast

gmercury

Posted
  • Author
Posted

Those look good, I have seen similar ones to yours. I have seen them where the rail is chrome and the ends are black. I thought they look good as the color was broken up a bit.

gmercury Enthusiast

gmercury

Posted
  • Author
Posted
i have a set of the stainless putcos on mine

 

 

If you dont mind me asking! How much did you give for those? Just looking for a ballpark figure. I like the stainless as I have Taupe Gray so I think they would look better. Would be cool if you can get color matched!

khancock Enthusiast

khancock

Posted
Posted
i have a set of the stainless putcos on mine

Have any more pics beyond the sig?

  • 2 weeks later...

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,812
    Total Members
    8,960
    Most Online
    Artemis
    Newest Member
    Artemis
    Joined

  • Who's Online   4 Members, 0 Anonymous, 1,234 Guests (See full list)

  • Latest Articles

  • Posts

    • ManyCamaroz
      “Service Emission System” & “175 miles until “65 MPH Max Speed”

      By ManyCamaroz · Posted

      I don't drive this truck on a regular basis since I have a new company truck with no out of pocket fuel or maintenance cost. Yesterday I got it out to run some errands and got the title message on my DCI. A quick Google search suggested to first clean the Map Sensor. I pulled it out and it was sooty so cleaned it up and reinstalled it. Issue not resolved. My OBDII is a couple years old so didn't see any codes. Today I took it to a friend at AutoZone to get him to check it with his reader. It had the following codes: P20C3 P02BB P221F Stating the most likely solution is to replace diesel emission fluid (DEF) tank assembly.   So, I guess a trip to the dealer is necessary. I read where there was a backorder on these tank assemblies several years ago so hope that has been resolved.
    • Chuck FB
      Do you keep your tires at full capacity? 80psi

      By Chuck FB · Posted

      Are you using a weight distribution hitch system with your trailer as that alone can change the actual tire pressure requirements needed. It would prove interesting to see what the actual individual axle weights are on your truck when you are hooked up to the trailer. In fact when your hooked to the trailer, typically if anything unless it has a large capacity weight distribution system that is over cranked, often the weight on the front axle will be less when hooked up vs driving empty and certainly if one doesn't have a weight distribution hitch. Really the only times one may get up there with weight on the steer axle is if there was a snow plow mounted on the front or a motorcycle on a rack or with a very large jockey tank full of fuel at the front of the box that transfers a bit of its weight to the front axle.    And of course your tires carry more weight for a given tire pressure due to their size vs a stock sized tire so there is that to take into the equation as well. 
    • Artemis
      New Member Just Bought a Vtrux

      By Artemis · Posted

      Great info here thank you. I just joined, we have a 2014 Silverado truck we bought about 4 years ago with less than 5,000 miles on it. It has approximately 24,000 on it now. It appears to have all the standard issues that people are talking about. Occasional charging problems especially using 110 volt, occasional blinking triangle where nothing will turn on when first starting the truck but it will reset itself if you wait 10 to 15 minutes. Noisy coupler between the flywheel and the generator. Our truck is speed limited to 74 mph, is there any way to change that? The latest issue we have been dealing with is when driving long distance on the highway at full speed the generator does not keep the batteries charged. The meter will go into the yellow/red border Zone for charge status and the yellow triangle will illuminate solid but the generator will not keep the battery charged, not sure why the controller doesn't tell the gas engine to increase RPM to increase generator output it usually stays well below 25 kilowatts even though the battery is discharging and I have to slow down the highway to 45 mph and eventually pull over and let the truck idle to charge the battery so I can continue driving at speed. Has anyone had this issue before or have any idea how to diagnosed it? When via Motors was around it they were very helpful at troubleshooting. This becomes much if the Terrain is hilly and you're towing a small trailer
    • Z45
      Tonneau cover that does not leak water

      By Z45 · Posted

      I have the GMC accessory (REV) cover installed by dealer. Ordered with the truck.  They did a very good install job, can't find a single issue. Some water gets in around the tailgate but no where else.  You can see daylight around the tailgate but that's not the covers fault.  Installation is means everything. Guys at my dealer were seasoned pros, not inexperienced here today good tomorrow types, like many dealers employ for these jobs.   I don't mind paying for a professional job.    
    • Haufski762
      Tonneau cover that does not leak water

      By Haufski762 · Posted

      Like others have said, they will all leak. Mainly at the corners.   I have owned several and the best has been my current one. Revolver x4

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...