Jump to content

Engine Hot A/c Turned Off Code - Not Really Hot

merf23

By merf23
in Ask A GM Technician

 Share

Recommended Posts

merf23 Enthusiast

merf23

Posted
Posted

I have a 2008 1500 4x4 4.3 V6 with 40000miles. Recently the ENGINE HOT A/C TURNED OFF warning pops up, but the engine isnt really hot. It seems to reset itself after a while. I though it did it more in wet weather, but today is dry (though yesterday rained). It did this yesterday. FIrst i disconnected the temp sensor on the left head, then reconnected it. It looked clean. This did nothing. Then, I disconnected the battery, and when i reconnected it 20 min later it was back to normal. I drove about 20 minutes twice today, at the end of the second trip it did it again. There was a recall to remove the insulation from the under seat computer, which i had done. It had the problem prior to this, and still does. Its probably occurred 10 times in the last 6 months, 7-8000 miles.

 

DO i justs need a temp sensor, or is it possible more involved?

 

thanks

Sean

beave84 Enthusiast

beave84

Posted
Posted
I have a 2008 1500 4x4 4.3 V6 with 40000miles. Recently the ENGINE HOT A/C TURNED OFF warning pops up, but the engine isnt really hot. It seems to reset itself after a while. I though it did it more in wet weather, but today is dry (though yesterday rained). It did this yesterday. FIrst i disconnected the temp sensor on the left head, then reconnected it. It looked clean. This did nothing. Then, I disconnected the battery, and when i reconnected it 20 min later it was back to normal. I drove about 20 minutes twice today, at the end of the second trip it did it again. There was a recall to remove the insulation from the under seat computer, which i had done. It had the problem prior to this, and still does. Its probably occurred 10 times in the last 6 months, 7-8000 miles.

 

DO i justs need a temp sensor, or is it possible more involved?

 

thanks

Sean

 

 

Do you have a block heater?

merf23 Enthusiast

merf23

Posted
  • Author
Posted

no block heater...Connecticut isnt quite that cold.

 

it did it again. i disconnected the battery for 1 min, and that reset it

  • 5 months later...
masabe New Member

masabe

Posted
Posted
no block heater...Connecticut isnt quite that cold.

 

it did it again. i disconnected the battery for 1 min, and that reset it

 

This problem is all over the internet but I have yet to see a reasonable fix posted. I see some say to replace the thermostat, but the temperature guage drops to lowest reading instantly, which tells me that the engine temperature is not actually changing. Plus the problem can linger a few days and then the guage will instantly jump to a correct reading and all will be ok, until next time. some have said they have replaced the temperature sensor with no luck. Does anyone know the answer or can they explain how the thermostat can cause this to happen? I am thinking the computer must be involved in this somehow.

redvett Senior Enthusiast

redvett

Posted
Posted

If the engine was hot 255F or higher the PCM would have a code and the SES light would have been on. I suspect a electrical problem possibly the cluster. BTW the PCM is not under the seat its in the engine compartment.

Beer Belly Enthusiast

Beer Belly

Posted
Posted

I was just going to post the same problem with my buddies 2008 Impala....probably the same issue

  • 2 weeks later...
texas2golfer New Member

texas2golfer

Posted
Posted

Here is my situation. 4.8l v6. 2008. Truck has no issues as long as the outside temp is about about 75*. Once temps go below that I have problems. I leave to go to work and truck has sat all night. Once I drive about 7 miles the temp guage goes from normal to nothing and my A/C wont work. If I disconnect the battery the guage goes back to normal and the A/C works fine until the next morning. Also if I don't disconnect the battery I can get on the highway on the way home and it will start working within 100 yards of the same place every day. I have no problems in the summer, but on the coldest days after sitting all weekend it shows engine hot. It has got to be something to do with the ambient temp.

  • 3 months later...
masabe New Member

masabe

Posted
Posted

I have found This is a common problem. GM engineers have apparently decided that if the engine temperature is too low (example 195deg) that they will display "engine too hot turning ac off". I had the same problem and replaced the engine temperature sensor but that didn't fix the problem. I had GM replace the thermostat and that fixed the problem. It doesn't make sense to display this on an engine that is too cool, but that is how it works.

  • 8 months later...
naedoba New Member

naedoba

Posted
Posted

This happened to me three times in my 2008 Silverado (4.3 V6). I took it to the dealer and they replaced the thermostat free of charge under the powertrain warranty. Aggravating, but at least it was a free fix.

  • 3 years later...
Jodi Parker New Member

Jodi Parker

Posted
Posted

I have a 2007 Chevy Silverado, with this same issue, I have changed the thermostat twice and it still keeps happening. Last Thermostat change the error did not happen for a few months but started up again and we finally have cool weather. Stopped unplugging battery to reset and when the weather is cold in the morning the temp guage will start up on it's own again, but the warmer the day gets or the longer drive the truck it comes back on, very annoying any real answers for the fix out there.

  • 4 weeks later...
fardanoh New Member

fardanoh

Posted
Posted

I Have the GMC Sierra 3500 HD with a Vortec 6.0L . I've faced this problem well over a year now, and i only encounter its appearance after it rains, while in summer the engine works perfectly. i knew that the problem is back only from the temp gauge going lower to 90 degrees when its normally 100 (Celsius because I'm in Dubai) but i know the normal engine temp is 100. I've changed the thermostat earlier but the problem wasn't fixed, i cleaned out the battery wires after it then the problem was fixed for well over 9 months. And now the problem is back and its taunting me and really really pissing me off. Please HELP me because its my daily driver truck and i just wanna get over with this shit and get it fixed. One trick i keep doing when this appears is that i disconnect the Battery wires and reconnecting again then the problem is fixed for a few hours, then its back again. The temp here in Dubai is over 40 degrees Celsius and i always boil while driving, Hell i even had to do the battery trick even when i was on a date. TWICE for gods sake, she never called again....

  • 1 year later...
Hoodman New Member

Hoodman

Posted
Posted

Hi everyone,

 

This is to help whoever can benefit from it.

 

First my background. 28 years as an ASE Master, L1, CA Smog Tech, B & L Inspector. Been doing this way too long!

 

This same issue started six months ago on my personal truck but it was very random to say the least. The problem would always disappear by the time I got to my destination until last week. Going by the symptoms, I knew this was a electrical/electronic problem and not a mechanical (thermostat) problem.

 

My diagnostics lead me to the BCM. Problem is that as soon as I touched the wire harness going to the BCM the fault disappeared and has not returned. I did however unplug and inspect for signs of poor connections and broken wires at the BCM. I have seen way to many times that wires will break inside the insulation due to excessive stress caused by engineers. The harness is very tight going to the BCM connectors. I hope this helps some you and I will add more if my ghost shows up again.

AgBioBen New Member

AgBioBen

Posted
Posted

Bought a 2011 Silverado a few months ago, same problem. Changed the thermostat to be certain and there was nothing wrong with it. Now I have a flashcal and I checked the engine temp when this A/C off code came up and the temp is just fine 168 at the moment (even though the needle stays at 0) No other codes or problems. Like you I suspect it's wiring or a connection. Thanks for the heads up, I'm going to see if it's around the BCM as well.

AgBioBen New Member

AgBioBen

Posted
Posted (edited)

On my way to work I received the same error again. I reached my left foot up behind the dash and tapped a wiring harness and immediately the error disappeared and the gauge went back to normal. Now to figure out which one it was.

Edited by 11BSilverado

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • asilverblazer
      Cold start Miss, oil in cylinder

      By asilverblazer · Posted

      I have a hard time seeing oil from 'below' the rings 'pooling' in the cylinder. For an amount great enough to pool getting past the rings I would expect to see that same amount contributing to other noticeable symptoms, low compression, blow by, etc. You could try investigating for a stuck, gummed or carboned up ring, maybe an oil with different detergent strategy. Some other shade tree solutions like adding a detergent (or mystery oil) to the chamber and letting it sit, I've also heard of a heavy use of 'engine braking' to load the rings differently.   I would first be looking at oil entering from 'above' via a head issue, or intake/PCV issue. I suspect that the oil is entering cylinder 8 combustion chamber at all times but is getting burned off during each combustion event preventing a 'pool' from forming and lessening visible oil burning smoke. This leads back to valve stems or PCV system as the only route for oil to enter the chamber from. I would expect a PCV issue to not be isolated to cylinder 8 though.   Other considerations, how long does it take the pool to form? Could you look for the oil trail via the borescope? (Run the truck, shut the engine off, as quickly as practical, pull the plug and insert the scope and record to see how long and hopefully where from.)  
    • Atlas
      Gas Prices

      By Atlas · Posted

      National Average back up to $4.04 for gasoline and $5.35 for diesel.   https://gasprices.aaa.com
    • Keith179
      Cold start Miss, oil in cylinder

      By Keith179 · Posted

      I’m out of ideas on this truck. 2020 Silverado 1500. 5.3 135,000 miles. Has a p0308 and p050d codes. Smokes From exhaust when cold. Compression test passed. New plugs, wires and coil on cyl 8. Same issue. New coil on 8, no change. Replaced injectors, no change. Bore scope showed oil pooled on the piston after sitting overnight. Pulled head and had machine shop check it out. No cracks. Stem seals looked good, replaced anyways. He also ground valve seats. Put it all back together and still have the same issue. Bore scope shows oil on the piston again. Leaning towards maybe a cracked ring but unsure. Cylinder looked good when the head was off, no scoring or scratches. Any ideas on what else I should look for?  Appreciate the help 
    • HeronLeal
      2021 Silverado 2.7L – N232395310 – Can someone with GM dealer access check my VIN?

      By HeronLeal · Posted

      Just want to make sure it is covered by Special Coverage N232395310 Evaporative Emission Purge Pump 2021 Silverado 1500 Custom 2.7L L3B ~100k miles I'm getting DTCs P146B and P146F. VIN 3GCPWBEK2MGxxxxxx   I spoke to a person that works at GM and he said it is not covered after checking my VIN.   Is there anyone here who currently works for a GM/Chevrolet dealership and has access to GM Global Warranty Management / Investigate Vehicle History who could explain how the VIN eligibility is determined?   thank you    
    • jgaudet99
      Tire psi

      By jgaudet99 · Posted

      Thanks for all that information, I might purchase one and see if it will work for me, if not they may let me return it! Yes for sure the tires are definitely within limit for my truck empty, and when I do tow I'll definitely make sure to raise the rear psi for the amount of weight that's going to be on it.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...