Jump to content

Rockin' And Roddin' Rantoul


kawtoy_77

Recommended Posts

Posted

WHEN: June 18th 4pm to 10 pm

 

WHERE: Sangamon & RT. 45, Rantoul, IL

 

WHAT: Car & Bike Show/Street Dance Brought to you by Hot Rods & Hooligans Motor Club

 

There will be a street dance from 6pm-10pm while the band "Back Paiges" plays. Food will be served by "Rubes Country Cooking", and drink specials brought to you by "TNT Tavern" (alcohol is limited to the bar property)There is a pretty good chance Tom Meents will be there with his monster truck, and Greg Reynolds from Reynolds Towing will have his $975,000 Rotator Semi wrecker truck draping a 50' American Flag over US Route 45. This should be a HUGE event. Freebies will be handed out over the course of the night, and bring the Kids there will be activities for them as well.

 

 

!!!!ALL CARS & BIKES WELCOME!!!!

tuner cars, muscle cars, lowriders, rat rods, hot rods,

antique cars/bikes, japanese bikes,

american bikes, british bikes,

diesel tuners, 4x4s, truck tuners, all are welcome!

Donations accepted upon entry

Peoples choice; Special hand made trophies awarded

50/50 raffle

No Admission Fee, but donations are welcome.

 

 

 

I will be there, WILL YOU?

KAWTOY_77biggrin.gif

 

 

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,903
    Total Members
    8,960
    Most Online
    RyGuy43
    Newest Member
    RyGuy43
    Joined
  • Who's Online   5 Members, 0 Anonymous, 395 Guests (See full list)

  • Latest Articles

  • Posts

    • This is NOT impact damage nor neglect. There were previous class action lawsuits because of such paint preparation st GM manufacturing plant. Not just the Cherry Red Color. This paint is applied in three processes to obtain the desired color.  The manufacturer will cover for 36 months or 36k miles only. That rust is actually corrosion because of the paint process failure. Corrosion is covered for 100,100 miles or a certain months. However their corrosion doesn't include this type. Go figure. Clearly manufacturer knew from previous paint issues. This started 3 weeks ago out of the blue.  
    • Is it time to put a piece of tape over the CEL? 
    • consider doing electrical testing?  I would guess some power or ground wire/connection has a problem.   alldata.com has wiring diagrams, connector pinouts and diagnostic procedures you can use to find where the problem is.
    • can you tell if the reader is actually trying to get codes, and the pcm is reporting none, or is your reader just silently failing because it's not communicating with the pcm?
    • Any joy with this truck seems to be short-lived.   The CEL for P0172 ("bank 1" too rich) is now "intermittent".   I'm not sure where to check, or re-check, and my energy to keep chasing problems with junk is wearing thin. The P0172 seems to set as I'm coming to a stop, completely off the throttle, when fully warm. At least, that's what it's done the 3? times it's set.   Everything appears normal on the scanner EXCEPT long term fuel trim. There's only one bank on this vehicle because it's an OBD 1.5 with only one upstream O2 sensor. At idle, it's around -16.4% and will dip to -18% occasionally at idle or off-throttle. LTFT approaches 0 when throttle is held at 2500rpm. Short term appears normal, much closer to zero all the time. The LTFT tells me the engine is running rich at idle but compensating at higher load. But, why?   The EVAP purge valve doesn't appear to be leaking/sucking fuel vapor continuously. Is it sticking just as I come to a stop and the engine is choking on fuel vapor and sets the P0172? But that doesn't explain the persistently negative LTFT. Disconnecting the purge valve doesn't seem to make any difference.   I suppose that leaves another dang issue with the fuel injector. A leaking fuel pressure regulator, a new leak in the spider, or a leaking fuel injector/poppet valve I didn't see, or a small crack in one of the spider legs.   The vacuum line leading to the fuel pressure regulator doesn't have raw fuel in it. It doesn't even smell like fuel when it's pulled off, not until you suck air through it, then you can tell it leads to a fuel component. I'd consider that normal? Nothing is signaling this is a FPR issue from the outside, at least.   The oil smells like fuel but it's not building volume. I've noticed most oil in most engines smells like fuel to some degree so it's hard to say if the smell is an issue or not. Or if the engine just still smells like fuel because the crankcase was full of it a few hundred miles ago. But it's been changed twice since that original issue of the leaking fuel line dumping fuel into the intake.   Patience is running very thin. Every win seems to be accompanied by two steps backwards, or another issue that leads to removing at least the top half of the intake manifold. Enough! LOL
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...