Looking for help with fuel system control module

[Mfire123]

Sorry for the novel.
 

I have a 2013 Silverado 1500 5.3 4x4 and I went to start it last week and it sputtered and died a few times and of course the check engine light came on. Scanned it and code PO69E came up. I purchased an oem fuel system control module and had a shop program it to my truck. They said they installed it and cleared codes and drove it and check engine light came right back on and  it’s pretty much doing the same thing. If it’s been sitting for a little while it will sputter out and die. If you then come back later it will start rough but it will start and run. 
 

Anyways, any advice on where to look next? I was able to run the fuel pump by jumping it from the harness that plugs into the fuel system module. I also noticed that when I pull the fuel system control module fuse (yes the truck will die) the check engine light turns off.  I’m wondering if anybody has had a similar issue that can point me in the right direction. 

 

thanks
 

[Sharpz]

I would look to making sure you have good connections, and that your pump is putting out the proper fuel pressure.  Living in the north east I imagine these connections can get pretty corroded.  Especially if they still put these modules where your spare tire is located.