Jump to content

Upshift indicator light...

phire

Recommended Posts

phire Enthusiast

phire

Posted
Posted

Alright, well I have a manual as you can tell from the subject lines and I was curious if I'd be wasting my time and sounding like an idiot if I were to call my local Chevy dealer to ask them if it would be possible to have them 'program' the computer to NOT use the upshift indicator light? I mean, I know how to drive a stick.... being doing it for years and the thing is never right anyways. I mean, I can be in 4th gear cruising along at 30mph, 1100rpms and it wants me to go to 5th..... It's not THAT annoying but if it can be shut off, I'll be right there first thing in the morning...

SoCalChris Enthusiast

SoCalChris

Posted
Posted

It annoys me too...

 

I do a lot of off-road, mountain driving, and I'll be headed uphill, going about 40 mph, and it will want me to be in 5th gear, even though I'm at a really low RPM.

 

I have to say, this is the "pushiest" vehicle I've ever owned. It complains about what gear I'm in, beeps constantly at me if my passenger or I don't have our belts on, etc... I don't like my truck trying to outsmart me! :cheers:

Rammer Enthusiast

Rammer

Posted
Posted

Your local tuner can diable the shift light. The dealer might have to request a whole new calibration from GM.

Rolandd Enthusiast

Rolandd

Posted
Posted

I liked the way a VW Rabbit that came into the shop decades ago had been disabled. The owner had put a very small drillbit through the cluster lense and into the light (LED) disabling it. It was a subtle but clear statement of where s/he was with that feature. I would not recommend doing this with the current cluster as you are as likely to put a hole through a chip or other circuitry as the light. For all we know, there is probably an error code on the ODBC-II system when that light fails.

phire Enthusiast

phire

Posted
  • Author
Posted
It annoys me too...

 

I do a lot of off-road, mountain driving, and I'll be headed uphill, going about 40 mph, and it will want me to be in 5th gear, even though I'm at a really low RPM.

 

I have to say, this is the "pushiest" vehicle I've ever owned. It complains about what gear I'm in, beeps constantly at me if my passenger or I don't have our belts on, etc...  I don't like my truck trying to outsmart me! :cheers:

 

 

 

 

haha, it is rather pushy I've noticed. It wants things done ITS way or the highway... literally... hehe no pun intended. Anyway, all my GM 5spd's have been like this. The least pushy is the 96 cavalier my wife owns. If you ignore the light it will go out after a few seconds until you shift out of that gear.

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • KARNUT
      Gas Prices

      By KARNUT · Posted

      I like things to be more nailed down. For instance. People ask why my father left a multi million dollar business in NJ in the seventies and started over in Texas. The answer is simple, payola, threats and quality of life. He didn’t like the game. And he didn’t want his kids to be wrapped up in that mess. That’s nailed down no guessing. 
    • KARNUT
      OCI, not when but why?

      By KARNUT · Posted

      So any kind of deviation is not permitted. Even if it manages to touch on Oils Chain intervals only if, it addresses your latest threat. Boring.😴 
    • Jus Cruisin
      Tonneau cover that does not leak water

      By Jus Cruisin · Posted

      The tailgate of pickups is not designed to be water tight. There are seal kits for them but I doubt they work effectively. But, I've not tried them. I always have hard folding tonneau covers and the BakFlip brand has been my favorite. And, for the most part, the bed stays dry. I would invest in some bins that can be closed to better protect sensitive stuff. 
    • parthery
      Tonneau cover that does not leak water

      By parthery · Posted

      A properly installed tonneau will keep out 95% of the water.  As others have said, the only way to be completely dry is to either get a topper or an SUV.   I've run virtually all the trifolds and hard rolling that are out there.  My thoughts:   1.)  The leak points of any cover will be the front corners, and around the tailgate.   They will also leak if the rails are not installed properly.  If you take a electric/cordless ratchet and snug down the clamps, you run the risk of overtightening which causes the rails to sag.  When the rails sag it creates a gap between the rail and the bed cap and this lets water in.   2.)  Different manufacturers use different methods to try and seal the front.  The "driest" setup is probably the Leer HF650M, which uses double seals all the way around and doesn't require a foam seal across the front edge of the bed.  The Realtruck trifold covers (Bak, Undercover, Gator, etc...) all use a foam seal across the front, and drain tubes.   3.)  Realtruck has standardized the way that the cover attaches to the rail.  With the exception of the Extang Endure ALX, all other Realtruck covers use a plastic clamp which slides into a channel, hooks onto the edge of the rail, and tightens down. The "Realtruck Advantage" covers sold by GM dealers as an OEM accessory still use the "bolt through the panel" installation method.  Problem with these is over time, water gets past the rubber seal, into the panel, and once they become waterlogged they begin to delaminate (and weigh a ton.)   4.)  Unless you are using GM Rewards points, buy your cover separately.  Realtruck offers a 5 year warranty on BAK, Undercover and Extang covers.  Gators get either a 2 or 3 year warranty.  If you have an issue, they are much easier to deal with.  If you have an issue with an OEM GM cover, you have to go through the service department and GM Warranty processes to get it taken care of.   Recommendations based on my experience:   Hard folding:   1.)  Undercover Ultra/Armor Flex (identical except Ultra has carpet on the underside and a smooth finish.  Armor has no carpet but has a Line-X coating on the outside.) 2.)  Leer HF650M.  Has 4 panels instead of 3.  Double seals to keep the water out.  Downside is only a 3 year warranty and warranty only honored if you purchase from a Leer dealer.  If you have your dealer install it or buy off Amazon they won't warranty it. 3.)  Bak MX4.  They sell a ton of them.  A good cover for the money when you can find one on sale.  About to be redesigned to include a spring to ease opening and closing. (Supposed to be released 7/26.  Bak MX4 EZ-Lift)   Hard rolling:   Bak Revolver X4S or X4TS (has t-slot rails.)  Personal favorite and the one I use on my truck.  Easy to roll up one handed.  Doesn't block the rear window.  Only costs you about 6" of the bed when open as opposed to a retractable canister which eats up about a foot of bedspace.  Downside is it's either all the way open or all the way closed.   Good luck with you search.    
    • cherryred21duramax
      Can anyone decode a VIN to determine if this truck has had emissions issues or a recall?

      By cherryred21duramax · Posted

      Does any of this change if the seller dropped the price to $22.5k?  Mechanic is supposed to verify the transmission concern but they have not got back to me yet.  Even if a transmission needed to be purchased, I'm looking at <$30k which puts me right back to where I started.   In the meantime, I test drove 2 trucks locally back-to-back, one Denali and one SLE, the SLE was noisy, jerky, and did not inspire confidence, while the Denali was over $30k but just sold the other day.  If $32k buys you a Denali with 100k miles and this truck can be had for $32k with a brand new transmission, with GM parts warranty, does that skew things?   FWIW, all the trucks I drove locally had a much worse service history - emissions work, valve body work, one even had the whole transmission replaced with lower mileage than the one in TX.  I'm guessing those were "short trip" vehicles, as they only racked up around 100k miles in 6 years - a lot less than 164k miles in just under 6 years.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...