F/s Warn Brush Guard - # 76450 - Black

By jnpaddison
July 21, 2008 in Classifieds (Buy/Sell/Trade)

Recommended Posts

jnpaddison

Posted July 21, 2008

This is only the guard - not the transformer unit that mounts to the frame

Does not fit 1500 correctly - 3 of 4 bolts are only accessable

Lower bar has 0.50 clearance to body fascia of 1500 model bumper

For a brief moment in time , the WARN pdf showed it did fit the 1500 - now since revised to #76745 - of which is now on the truck

Was on for about a month - no dents or dings -only surface blemish would be where the bolt face would make contact with the brace

Shipped in WARN box with instuctions and hardware

$125 shipped - paypal or check

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

Recently Browsing 0 members
- No registered users viewing this page.
Forum Statistics

250.4k
Total Topics

2.7m
Total Posts
Member Statistics

342,842
Total Members

8,960
Most Online

Newest Member
CaptainDad
Joined 7 hours ago
Who's Online 6 Members, 0 Anonymous, 604 Guests (See full list)
- Steve-2019
- c4racer2
- VE4ADB
- Byrds8
- RyanbabZ71
- KARNUT

Latest Articles
- Hummer Turns 25 and GMC Brought the H2’s Yellow Back
  Wednesday at 06:04 PM
- What’s New for the 2027 GMC Yukon and Yukon XL
  July 13
- Got a “Service Door Latch” Alert? Fix It in a Minute
  July 9
- GM Recalls Cadillac VISTIQ Over Power-Folding Seats
  July 8
Posts
- Transmission temperature 10speed with 3.0 LZO Duramax
  
  By newdude · Posted 26 minutes ago
  
  LM2 and LZ0 DO NOT have a thermostat in the valve body. LM2 and LZ0 still have the water to oil heat exchanger that the ATF goes through no matter what. So if the thermal bypass in the lines to the aux cooler is closed, ATF goes out the transmission, into the water to oil exchanger, to the thermostat and then back to the transmission. When it gets hot enough to open the TBV in the line, it will then flow to the aux cooler out front to regulate temperatures. The cooling system is going to warm the ATF up as the exchanger is part of that entire Active Thermal Management cooling system. LM2 and LZ0 DO NOT have a thermostat in the valve body. Just the one in the lines. Stock TBV opens at 194F. From TSB 22-NA-182 10 Speed (10L80, 10L90, 10L1000) - 143F (61C) - TBV is within the valve body on all listed applications except those equipped with 3.0 (LM2) (LZ0) Diesel. The (LM2) and (LZ0) Diesel, the TBV is on the frame rail, external to the transmission and opens at 194F (90C). As for your big Duramax, the transmission cooler lines still flow through the side tank on the radiator, so deleting the TBV in the valve body will only lower it so much.
- Transmission temperature 10speed with 3.0 LZO Duramax
  
  By Rick_ · Posted 58 minutes ago
  
  Installed the PPE bypass on the RST last week. With ambient temps between 75-95, the trans temp dropped from 195-198 unloaded to between 180-185. Not what I was expecting (also has the Max Trailering package). I have a Nextgen diesel valve body upgrade kit going in this week and the remaining thermostat in the pressure regulator valve will be removed and I'll see what happens. I did the same mod in the Valve body upgrade kit for my '24 3500 HD Duramax and I haven't seen much difference in trans temp but I've just been running back and forth to town so far.
- Different requirements for oil filters?
  
  By Black02Silverado · Posted 58 minutes ago
  
  It's going to last a long time. You seem to take care of your vehicles and that is key. I wish I kept my 2002 Silverado. These new vehicles are not built with quality anymore.
- Auto start stop disable
  
  By kr477 · Posted 1 hour ago
  
  2022 Refresh LTZ with the console - I put a 4D tech Start/stop eliminator in the truck a week ago and it works great. Yes there are a number of panels you need to take off to get access but its not that hard to do. Figure I spent about 1-1/2 hrs doing the truck and another 10 minutes installing one in the wifes car - that had easy access.
- Forward collision and lane keep assist still a problem on 2022 refresh?
  
  By kr477 · Posted 1 hour ago
  
  Did they do this TSB from the post above? New updated program required to get this running is #PIT6504 dated Apr 1 , 2026. Appears the applications cover numerous Chevy and GMC vehicles with fwd col, AEB, and LKA options. Hopefully this helps someone out in the future with these issues.
GM-Trucks.com Clubs
- Black Truck Club
  
  Open Club · 612 members
- White Truck Club
  
  Open Club · 380 members
- Canadian Owners Club
  
  Open Club · 282 members
- Red Truck Club
  
  Open Club · 157 members
- diesel 3.0
  
  Open Club · 281 members
- Texas Owner's Group
  
  Open Club · 371 members
- NorthSky Blue Club
  
  Open Club · 118 members
- Midwest Owner's Group
  
  Open Club · 213 members
- 2015 Custom Sport Club
  
  Open Club · 5 members
- GM Snow Plowing Club HD
  
  Closed Club · 14 members
Popular Contributors
- Week
- Month
- Year
- All Time
1. 1
  
  Grumpy Bear
  20
2. 2
  
  Chuck FB
  17
3. 3
  
  newdude
  16
4. 4
  
  CamGTP
  10
5. 5
  
  txab
  10
Show More