New Zone 2'' Lift Kit / New Grill.

[Lahey99]

installed my zone 2'' lift kit today and also got a smoken deal on the gmc chrome pkg grill, here at the gmc dealer they go for $369CAD last night i found one online about an hr away brand new in plastic/box for $120 so i scooped that up right away. here are a few comparason pics and then just a couple i took up the street from my house. there was a guy in a silverado parked where i wanted to take the pics over looking the river, but oh well this should hold you guys over for a bit!

 

 

 

 

 

[ryan_hermanutz]

It looks good Josh. Did you do the leveling kit install yourself?

[Lahey99]

It looks good Josh. Did you do the leveling kit install yourself?

 

yes i did the front and rear myself aswell as the grill all this morning, took about 3 hrs as i had to run to canadian tire to get some things i didnt have. and i just notcied i must have knocks off one of the stabiltrak control wires off the rear because when i just went to take these pics i had an error service traction control / service stabiltrak light was on and dinging away, i will have a look at that in a few minutes when i go out into the yard to see if its something obvious. which im sure it is.

[MacA]

Nice job. Looks awesome!

[[email protected]]

That new grille makes it look soooooo much better.

[lsuguy]

That new grille makes it look soooooo much better.

That grille is a million times better than that last one.

[Big Whiskey]

Looks great!

[Lahey99]

thanks fellas...forsome reason it doesnt look like it has as much rake as it did stock? which doesnt make sense becuase it was 2'' added on all for corners?

[herkdriver007]

did you stack the rear block or just replace the OEM with the Zone block?

 

ck those abs connectors near the front brakelines; i know when I installed my rancho i forgot to clip on into place and it came apart, thus sending the "service stabilitrak" message on the DIC.

 

Looks good!!

[Lahey99]

did you stack the rear block or just replace the OEM with the Zone block?

 

ck those abs connectors near the front brakelines; i know when I installed my rancho i forgot to clip on into place and it came apart, thus sending the "service stabilitrak" message on the DIC.

 

Looks good!!

 

I don't think it is the front I'm thinking the rear because tha2 in the only spot where we messed with or even touched a wire. Oh and I stacked them but may chang it to just the 2 inch if I notice it is rough or don't like it in anyway

[herkdriver007]

double check your abs sensor wires coming down on each side...its possible one was pulled loose. On mine, I had to pop the plastic out of the frame so the wire was long enough.

 

I really need to extend those lines the right way though.

[Lahey99]

YEah the connector on the back was loose all fixed now