Cargo Management System (CMS) Measurement

[97whitez71]

Would anyone with the CMS mind taking a measurement of how far the CMS sticks out past the top of the bed rail if at all? I haven't been able to find a good picture to see if the CMS sticks out past the bed rails or not as I already have a toolbox that sits across the bed rails but would like the CMS for tying stuff down. I want to make sure the CMS will fit with my existing toolbox. Thanks for the help!

[AzDragonLord]

On my 2009 Sierra the CMS sits flush with the edge of the bed rails, so a toolbox should fit alright.

[Z45]

Here is a pic that might help

[cfeiring]

Here is a pic that might help

That is what my truck likes like.

It sits below the rails and I love the system worth the money and I even bought extra slide / tie downs.

too bad that they stopped the option.

bigger question is how much the tool box will come to the side of the box as the rails do stick out a bit off the sides as you can see in the picture.

Currently have a tropical storm outside so not willing to take the bed cover off and take pics in the down poor but will try sat to take a few measurements for ya if I can get some help to measure.

[97whitez71]

Thanks y'all! I think I'll have room. I really like that system and hope to find one cheap.

[citydriver]

61 1/2" from rail to rail, closer to 62" in the front where the plastic corners are and the front rail sticks out about 1 1/2" from the bed. You could leave the front rail off if you plan on leaving the tool box in, but you may not be able to install it at a later time due to the fact that the side rails will be in the way....just a thought

[97whitez71]

Thanks citydriver! I'd probably go ahead and install the front rail just in case I ever get rid of the toolbox.