-
Recently Browsing 0 members
- No registered users viewing this page.
-
Forum Statistics
250.3k
Total Topics2.7m
Total Posts -
Member Statistics
342,732
Total Members8,960
Most Online
-
Who's Online 10 Members, 1 Anonymous, 841 Guests (See full list)
-
Latest Articles
-
Posts
-
I really like the look of the new truck. I have a 2024 Sierra now and will keep it, but I'm jealous that the shifter is back where it should be... on the column! The goofy shifter in the console is one of the few things I hate about my truck. -
By SoCal Angler · Posted
After my recent rear end bumper damage, body shop has made the repairs and included a new OEM receiver hitch. I started thinking about how it was tightened...to specs or by hand or ??. I called the body shop and asked and they said it was tightened by an impact gun. I said I wanted it tightened to OEM specs. They said no problem, bring it to shop today and they will torque to specs, which they say is 74 ft/lbs. A couple of questions,,,, 1. Should new bolts have been used? If so, how many are there (bill shows one and four (I assume different areas of receiver). 2., Since they torqued with impact gun and now are going to probably loosen and then torque to spces, will that damage/stretch the bolts? 3. If old bolts were reused (truck has 9000 miles), is that a problem? 4. Any other things iI may have missed with regard to receiver replacement? NOTE: Attached are the receiver hitch specs from my digital OEM service manual. It shows to horizontal mounting bolts and four vertically mounted bolts. Other sections of manual reference eight vertical bolts. Thanks! -
Is this supposed to be in English? "close to 100 fake, new brake pads sign on the dash board" Pull the wheels off. Check the brake pad thickness. Check the sensors out. You could have good pads and the sensors aren't in to the worn out position, but have an electrical fault with the sensor or the plug wiring to the sensor. -
Gas or diesel??????????? You did not indicate. Your topic just says "2022 10L80".
-
Tomorrow I go in for my third joint replacement in jus a little over a year year! I am not worried about the surgery but I am a little annoyed about going through the recovery process again! I keep my frustrations to myself as I do appreciate that I am truly lucky. Knee, hip, and shoulder replacements are routine, safe and improve mobility. The next couple of days will be slow but every day following will see steady improvement in my mobility.
-
-
GM-Trucks.com Clubs
-
Black Truck Club
Open Club · 612 members
-
White Truck Club
Open Club · 380 members
-
Canadian Owners Club
Open Club · 282 members
-
Red Truck Club
Open Club · 156 members
-
diesel 3.0
Open Club · 279 members
-
Texas Owner's Group
Open Club · 371 members
-
NorthSky Blue Club
Open Club · 118 members
-
Midwest Owner's Group
Open Club · 212 members
-
2015 Custom Sport Club
Open Club · 5 members
-
GM Snow Plowing Club HD
Closed Club · 14 members
-
-
Popular Contributors
-
.thumb.JPG.2c573de60d3a3a4407c7d92298db46dd.JPG)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.