Jump to content

Recommended Posts

Posted

So I appear to have the dreaded faulty Trans Temp sensor.  Very erratic transmission temperatures, shows as low as 44 degrees each morning even though it's maybe 75 degrees at the lowest in the garage and recently had the engine light come on with p0700 & 7011.    I know the issue and the fix for it but have a few questions.

 

1. There's special coverage for this exact same condition for 2016's with the 6.2 and 8 speed but appears to be limited to 2016 model years only.  Why? If the same issue is happening (same engine/transmission combination) for my 2017? I assume there's nothing I can do about this but will certainly ask the dealer when it goes in on Friday. 

 

2. It's coming due for a full flush/fluid exchange. But the pan has to come off to replace the sensor/wiring harness. Is it still worth paying what I'm assuming is close to $200 for a full flush even though they already have to drop the pan to replace the sensor, or do I just let them fill it back up and call it good, knowing there's still plenty of fluid left that didn't get replaced? 

 

 3. Anyone know what the cost for this is?  It's a 2017 but outside the powertrain warranty by about 9 months and 12,000 miles.  It doesn't sound like a cheap fix. Which is why I'm curious about item #1.  

 

4. Is it safe to drive this way? I assume so but not sure what all the trans temperature readings impact?

 

Going to the dealer on Friday but hoping to gain a little more knowledge on the questions above from anybody has may have gone through this already. 

 

Posted

The repair costs about 200 with fluid. The dealer quoted some stupid g

High price, so I did it myself. 

 

It's probably not good to keep driving this way. The temp is used to determine shift points and pressures. There was more clutch material in the fluid than I would have liked.

Posted

Don't let them flush it with some random @ss fluid!!!! 

 

Mobil LV ATF HP Blue Label ONLY!  GM # is 19417577, and they should have plenty of it in stock in one form or another. 

 

GM has a fluid exchange method for the 8 speed shudder which is what GM calls a "triple flush".  Takes 16-20qts to do the job.  They hook up a cooler flow machine direct to the transmission for filling purposes only, and then hook a hose with a cooler line adapter to the transmission.  4 quarts out and shut it off, add 4 in and run it then drain 4 out and repeat to get as much of the old stuff out. 

 

Being the pan will be down, they will have added 6-8 quarts of fresh fluid back in, so if you wanted as much changed as possible, they'd have to run another 8 through it using the above method.  

 

This can be done DIY but would obviously involve dropping the pan multiple times.  

  • 3 weeks later...
Posted

To report back, the dealer confirmed it was the trans temp sensor, but for some unknown reason there's special coverage for 2016 but not an identical vehicle for 2017. Same engine, transmission, etc.  Total cost was $923 which included replacement of the sensor/harness and filter.  The paperwork has 12 quarts of fluid on it which I doubt they actually used by just dropping the pan.  Decided to skip the extra cost of a full flush and get the use out of the 8 quarts or however much the re-filled it with and then maybe do a flush in another 25k miles which will be just about 100k miles, at least it's got a new filter now and shouldn't have to drop the pan again later. 

  • 5 months later...
Posted

Good morning. 

'17 Silverado 95k miles on it. 

This code just threw on my truck yesterday. 

Still runs perfectly fine and the transmission temp seems to be somewhat normal.

I was going to attempt to replace the sensor and harness myself because my truck is out of warranty and I don't believe there is a recall on the 2017s.

 

Two questions

1) Can anyone provide some type of feedback on the difficulty of this replacement. 

2) I have searching and cannot find the exact sensor or part number to order.

 

Any and all feedback is appreciated.  Thank you

  • 2 weeks later...
Posted

Had this done back in July.  Noticed the temp display very erratic then eventually the light would come on and off with codes P0700 & P0711.  You have to replace the entire harness, local dealer did it for $923 which includes a new filter.  This is almost all labor.  Parts (Harness, Filter, and Fluid) only came up to about $200, rest is all labor.  Part number for the new harness is 24046895. 

 

As far as difficulty of replacement, there's plenty of you tube videos out there. Doesn't look too difficult as long as your comfortable removing the pan and valve body.   What I don't understand is why there is special extended coverage for this exact same issue/part through model year 2016 but not 2017?  

 

image.thumb.png.b0544a7f3e200486f4ca5c5f80586589.png

  • 1 year later...
Posted
On 7/12/2023 at 12:07 PM, jrmcswain said:

The repair costs about 200 with fluid. The dealer quoted some stupid g

High price, so I did it myself. 

 

It's probably not good to keep driving this way. The temp is used to determine shift points and pressures. There was more clutch material in the fluid than I would have liked.

did you have to program it or just plug and play with the new harness?

  • 2 weeks later...
Posted

I have a 2017 Chevy Silverado 1500 4-door with transmission temperature sensor problems.

I took it to the dealer and they can't get the parts..

 

Does anyone have the part numbers?

 

Appreciate the assistance..

Steve

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined
  • Who's Online   0 Members, 0 Anonymous, 1,352 Guests (See full list)

    • There are no registered users currently online
  • Latest Articles

  • Posts

    • My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • I have 2 choices. 
    • Do you have access to BP fuels? Some stations have Silver 91 E-0 priced the same as their 93 E-10.  There is a local Marathon with 90 alky free for $6 a gallon but I go down the road to BP for $5-ish. They also have a 100 E-0 but that stuff is $10 a pop. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...